User Manual

22
Mounting:
When mounting several hobs together you must use a reinforcement beam
between each hob as well as the silicone supplied with the hobs (see fig.)
1. Cut a hole of the calculated size in the table top
2. Place the individual hobs upside down on a mat. Take care that the top side is
not scratched.
3. Mount the clamping fittings in the holes in the side of the base panels (see
fig.)
4. Place the first hob in the hole.
5. Apply silicone to the two corners joining the next hob (see fig.)
Use only the silicone supplied with the hobs as this is intended to tolerate the
high temperatures of the appliance.
6. Push a reinforcement beam up against the hob. Apply silicone on the rein-
forcement beam (see fig.)
7. Tighten the clamping fittings to the table top using a screwdriver.
8. Repeat the process for the other hobs.
Silicone
11
Grill
1. Put the grill pan containing the
lava rocks in the grill.
2. Holding the grill rack with both
hands, guide it back at an angle
until it slots into place on the
grill.
3. Lower the front of the grill rack
until the connector engages.
If you are going to grill very fatty
food, you can replace the lava rocks
in the grill pan with water if neces-
sary. If you do this, the fat will drip
into the water and cool so quickly
that it cannot ignite. When using
water in the grill pan, keep an eye on
how much water is left and top up if
necessary.
Allow the grill to warm up on level
9 for 10 min. before starting to cook.
The grill can be set from 0-9, where
9 is the highest level. Grilling is
done between levels 6 and 9.
1. Press
k
.
2. Press
l
or
m
to adjust the grill.
Adjustment of the grill must take
less than 10 seconds, otherwise the
grill will turn off again.
2
3