FAVORIT SILENCE VI EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 PROGRAMMES . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 1. 3 SAFETY INSTRUCTIONS Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • • • • WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. Contact the Service to replace the water inlet hose. 1.3 Use • This appliance is intended to be used in household and similar applications such as: – Staff kitchen areas in shops, offices and other working environments – Farm houses – By clients in hotels, motels and other residential type environments – Bed and breakfast type environments.
ENGLISH 2. PRODUCT DESCRIPTION 1 2 3 12 11 10 9 8 1 Top spray arm 2 Upper spray arm 3 Lower spray arm 4 Filters 5 Rating plate 6 Salt container 7 Air vent 8 Rinse aid dispenser 9 Detergent dispenser 10 Cutlery basket 11 Lower basket 12 Upper basket 2.1 Beam-on-Floor The Beam-on-Floor is a light that shows on the floor below the appliance door. 7 6 5 4 • When the programme starts to operate, the red light comes on and stays on for all the duration of the programme.
www.aeg.com 3. CONTROL PANEL 1 2 3 4 5 6 7 8 9 1 On/off button 6 ExtraHygiene button 2 Display 3 Delay button 7 Multitab button 4 Programme button (down) 9 Indicators 8 RESET button 5 Programme button (up) Indicators Description Salt indicator. It is always off while the programme operates. Rinse aid indicator. It is always off while the programme operates. End indicator. 4.
ENGLISH Programme Degree of soil Type of load Programme phases Options 5 Normal soil Crockery and cutlery Prewash Wash 50 °C Rinses Dry Multitab 5) 7 1) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. (This is the standard programme for test institutes). 2) The appliance senses the degree of soil and the quantity of items in the baskets.
www.aeg.com 5. OPTIONS Activate or deactivate the options before the start of a programme. You cannot activate or deactivate the options while a programme operates. If one or more options are set, make sure that the related indicators are on before the programme starts. 5.1 ExtraHygiene With this option you have better hygiene results. During the rinsing phase, the temperature stays at 70 °C for at least 10 minutes. How to activate the ExtraHygiene option 1. Press ExtraHygiene.
ENGLISH 9 6. BEFORE FIRST USE 1. Make sure that the set level of the water softener agrees with the water hardness in your area. If not, adjust the water softener. Contact your local water authority to know the water hardness in your area. 2. Fill the salt container. 3. Fill the rinse aid dispenser. 4. Open the water tap. 5. Processing residues can stay in the appliance. Start a programme to remove them. Do not use detergent and do not load the baskets. 6.
www.aeg.com 6.2 Filling the salt container 1. 2. 3. 4. 5. Turn the cap counterclockwise and open the salt container. Put 1 litre of water in the salt container (only for the first time). Fill the salt container with dishwasher salt. Remove the salt around the opening of the salt container. Turn the cap clockwise to close the salt container. CAUTION! Water and salt can come out from the salt container when you fill it. Risk of corrosion.
ENGLISH 11 5. Set and start the correct programme for the type of load and the degree of soil. 7.1 Using the detergent A 1. B 2. 30 3. 4 MAX + 32 - 1 20 C 4. 5. 7.2 Setting and starting a programme Setting mode For some settings it is necessary that the appliance is in setting mode. Press the on/off button to activate the appliance. The appliance is in setting mode when the display shows 2 horizontal status bars. If the control panel does not show this condition, press RESET.
www.aeg.com Cancelling the programme 1. Press RESET. The display shows 2 horizontal status bars. Make sure that there is detergent in the detergent dispenser before you start a new programme. At the end of the programme The display shows 0:00 and the end indicator comes on. 1. Press the on/off button to deactivate the appliance. 2. Close the water tap. Important • Let the dishes become cold before you remove them from the appliance. Hot dishes can be easily damaged.
ENGLISH • Remove remaining food from the items. • To remove easily remaining burned food, soak pots and pans in water before you put them in the appliance. • Put hollow items (cups, glasses and pans) with the opening down. • Make sure that cutlery and dishes do not bond together. Mix spoons with other cutlery. • Make sure that glasses do not touch other glasses. • Put the small items in the cutlery basket. • Put the light items in the upper basket. Make sure that they do not move.
www.aeg.com 6. 7. Make sure that the filter (B) is correctly positioned under the 2 guides (C). Assemble the filter (A) and put it back in filter (B). Turn it clockwise until it locks. An incorrect position of the filters can cause bad washing results and damage to the appliance. 9.2 Cleaning the spray arms 9.4 Internal cleaning Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object.
ENGLISH Problem 15 Possible solution Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged. Make sure that the filter in the inlet hose is not clogged. Make sure that the inlet hose has no kinks or bends. The appliance does not drain the water. Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. The anti-flood device is on.
www.aeg.com 6. Adjust the released quantity of rinse aid. 7. Fill the rinse aid dispenser. 11. TECHNICAL INFORMATION Dimensions Width / Height / Depth (mm) Electrical connection Refer to the rating plate. Voltage 596 / 818 - 898 / 550 220-240 V Frequency 50 Hz Water supply pressure Min. / max. (bar / MPa) Water supply 1) Cold water or hot water2) (0.5 / 0.05 ) / (8 / 0.8 ) Capacity Place settings 12 Power consumption Left-on mode 0.10 W Off-mode 0.10 W max.
ENGLISH 17
www.aeg.
ENGLISH 19
117906230-A-272013 www.aeg.