FSK93800P USER MANUAL EN User Manual Dishwasher
www.aeg.com CONTENTS 1. SAFETY INFORMATION............................................................................................. 2 2. SAFETY INSTRUCTIONS.............................................................................................4 3. PRODUCT DESCRIPTION...........................................................................................6 4. CONTROL PANEL....................................................................................................... 7 5. PROGRAMMES...
ENGLISH 3 manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • Do not leave the appliance with the open door unattended to avoid stepping accidentally onto it. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean the appliance. If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. The appliance is to be connected to the water mains using the new supplied hose-sets.
ENGLISH 5 2.5 Internal light WARNING! Risk of injury. WARNING! Dangerous voltage. • If the water inlet hose is damaged, immediately close the water tap and disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. 2.4 Use • Do not sit or stand on the open door. • Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. • Do not drink and play with the water in the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 14 13 12 11 10 9 8 1 2 3 4 5 6 7 8 7 6 Top spray arm Upper spray arm Lower spray arm Filters Rating plate Salt container Air vent Rinse aid dispenser 3.1 TimeBeam The TimeBeam is a display that is shown on the floor below the appliance door. • When the programme starts, the programme duration comes on. • When the programme is completed, 0:00 and CLEAN come on. • When the delay start starts, the countdown duration and DELAY come on.
ENGLISH 7 When AutoOpen is activated during the drying phase, the projection on the floor may not be completely visible. To check the remaining time of the running programme, look at the control panel display. 4. CONTROL PANEL 1 2 3 6 1 2 3 4 4 5 5 OK key 6 Navigation key (down) On/off button Navigation key (up) Display Option key 4.1 Key behaviour • Long press (3 sec.) when a delay start or a programme is running will delete the delay start, the programme and options.
www.aeg.
ENGLISH 9 5.1 Consumption values Water (l) Energy (kWh) Duration (min) 11 0.832 232 AutoSense 45°- 70° 7 - 14 0.6 - 1.6 40 - 170 ProZone 50°- 65° 14 - 16 1.2 - 1.5 160 - 180 12.5-14.5 1.4-1.7 170-190 10 0.9 30 Glass 45° 12 - 14 0.7 - 0.9 82-92 Extra silent 50° 9 - 10 1.1 - 1.3 230 - 250 4 0.
www.aeg.com Settings Values Description Key tones Off Click Beep Set the sound of the keys when pressed. Volume From level 1 to level 10. Adjustment of the sound volume. Brightness From level 0 to level 9. Change the brightness of the display. Contrast From level 0 to level 9. Change the contrast of the display. Water hardness From level 1 to level 10. Set the level of the water softener according to the water hardness in your area. Factory setting: level 5.
ENGLISH 6.4 Starting the MyFavourite programme 1. Press and hold OK for about 3 seconds until the display shows the MyFavourite setting. 2. Close the appliance door to start the programme. 11 6.6 AutoOpen AutoOpen improves the drying results with less energy consumption. 6.5 How to save the MyFavourite programme You can only save 1 programme at a time. A new setting cancels the previous one. 1. Press the Option key. 2. Select Settings. 3. Press the OK key. 4. Select MyFavourite. 5. Press the OK key.
www.aeg.com Not all options are compatible with each other. If you have selected non compatible options, the appliance will automatically deactivate one or more of them. Only the indicators of the options still active will stay on. 7.1 Option list Options Values Description Delay start From 1 to 24 hours OFF (default value) Delay the start of the programme. XtraDry ON OFF (default value) Activate this option if you want to boost the drying performance.
ENGLISH Every time ECO 50° is activated, XtraDry option is off and needs to be chosen manually. In other programmes, the setting of XtraDry is permanent and it is automatically used in next cycles. This configuration can be changed at any time. Activating XtraDry option deactivates TimeSaver. 7.4 TimeSaver This option increases the pressure and the temperature of the water. The washing and drying phases are shorter. The total programme duration decreases by approximately 50%.
www.aeg.com German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Water softener level 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.4 36 - 45 7 23 - 28 40 - 50 4.0 - 5.0 28 - 35 6 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 2 <4 <7 <0.7 <5 1 2) 1) Factory setting. 2) Do not use salt at this level.
ENGLISH CAUTION! Water and salt can come out of the salt container when you fill it. After you fill the salt container, immediately start a programme to prevent corrosion. 8.3 The rinse aid dispenser The rinse aid helps to dry the dishes without streaks and stains. The rinse aid is automatically released during the hot rinse phase. You can set the released quantity of rinse aid between level 1 (minimum quantity) and level 6 (maximum quantity).
www.aeg.com 9.1 Comfort Lift CAUTION! Do not sit on the rack. Do not put excessive pressure on the locked basket. CAUTION! Do not exceed the max load capacity of 18 kg. CAUTION! Use only a detergent specifically designed for dishwashers. To ensure correct unlocking, lift the trigger handle completely and the basket slightly until the basket is disengaged on both sides.
ENGLISH 9.3 Setting and starting a programme The Auto Off function This function decreases energy consumption by deactivating automatically the appliance when it is not operating. The function comes into operation: • 5 minutes after the completion of the programme. • After 5 minutes if the programme has not started. Starting a programme When you activate the appliance, the display shows the programme list. The programme ECO is always the default programme. 1.
www.aeg.com Cancelling a running programme When you cancel the running programme the options are set to their default values. 1. Open the appliance door. 2. Press and hold Option for about 3 seconds until the display shows: Stop washing?. • Select Resume and press OK to continue with the running programme. Close the appliance door. • Select Stop and press OK to cancel the running programme. End of the programme All buttons are inactive except for the on/off button. 1.
ENGLISH 2. Make sure that the salt and rinse aid containers are full. 3. Start the shortest programme with a rinsing phase. Do not add detergent and do not load the baskets. 4. When the programme is completed, adjust the water softener according to the water hardness in your area. 5. Adjust the released quantity of rinse aid. 6. Activate the rinse aid empty notification. 10.4 Loading the baskets • Only use the appliance to wash items that are dishwasher-safe.
www.aeg.com 1. Turn the filter (B) counterclockwise and remove it. 7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A). 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.
ENGLISH 21 11.3 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do not use abrasive products, abrasive cleaning pads or solvents. 11.4 Internal cleaning 3. Wash the spray arm under running water. Use a thin pointed tool, e.g. toothpick, to remove particles of soil from the holes. 4.
www.aeg.com WARNING! Repairs not properly done may result in serious risk to the safety of the user. Any repairs must be performed by qualified personnel. With some problems, the display shows an alarm code. The majority of problems that can occur can be solved without the need to contact an Authorised Service Centre. Problem and alarm code Possible cause and solution You cannot activate the appliance. • Make sure that the mains plug is connected to the mains socket.
ENGLISH 23 Problem and alarm code Possible cause and solution The options of the program have to be set again every time. • To save your favourite configuration use option MyFavourite. Small leak from the appliance door. • The appliance is not levelled. Loosen or tighten the adjustable feet (if applicable). • The appliance door is not centred on the tub. Adjust the rear foot (if applicable). The appliance door is difficult to close. • The appliance is not levelled.
www.aeg.com Problem Possible cause and solution There are whitish streaks or bluish layers on glasses and dishes. • The release quantity of rinse aid is too much. Adjust the rinse aid level to a lower level. • The quantity of detergent is too much. There are stains and dry water drops on glasses and dishes. • The released quantity of rinse aid is not sufficient. Adjust the rinse aid level to a higher level. • The quality of the rinse aid can be the cause. The dishes are wet.
ENGLISH 25 Problem Possible cause and solution Dull, discoloured or chipped tableware. • Make sure that only dishwasher-safe items are washed in the appliance. • Load and unload the basket carefully. Refer to basket loading leaflet. • Place delicate items in the upper basket. Refer to "Before first use", "Daily use" or "Hints and tips" for other possible causes. 13.
www.aeg.
ENGLISH 27
117883331-A-512016 www.aeg.