User's Manual

English
56
Alarm function
NOTE: Important!
The alarm time cannot be set, activated or deactivated whilst the unit is searching for a
radio signal.
Setting of the Alarm
You can set two alarm times. Proceed as follows:
1. PresstheALMSETbutton(3)forapproximately3seconds.Thedisplayshows“AL1”
andthenumberoftheactuallysetalarmtimestartstoash.
2. Use the buttons UP (8) and DOWN (7) for setting.
3. PresstheALMSETbuttonforconrmation.Theminutesstarttoash.
4. Use the buttons UP and DOWN for setting.
5. Press the ALM SET button to set the second alarm time. Proceed as described above
for the setting.
NOTE:
• Ifyouwanttosetonlytherstalarmtime,presstheALMSETbuttonuntilthe
time is displayed again.
• PresstheALMSETbuttontodisplaythesetalarmtimesforashorttime.
Activate alarm times
You can activate the first or second alarm or both together.
1. Whenthetimeisdisplayed,brieypresstheALMSETbutton(3).Themessage“AL1”
appears on the display in place of the seconds display.
2. Press the UP button (8) to activate the first alarm time. The “
” symbol appears on the
display.
3. Press the ALM SET button again. The message “AL2” appears on the display.
4. Press the UP button to also activate the second alarm time. The “ ” symbol appears
on the display.
5. Press the ALM SET button again to return to the time display.
A beep will sound when the set alarm time is reached. The intensity of the beep increases
slowly.
NOTE:
If the alarm is not interrupted, the beep switches off by itself after two minutes.