Operating instructions

Multiplexer

PG1/PG2-Interface TTY aktiv

This pining is the same pining of the PG-Interface on a Bosch CL200, CL300, CL400.

Signalname Notation Pin

External ground Shield 1

Receiver plus TTY IN+ (RxD+) 12

Receiver minus TTY IN- ( RxD-) 24

Transmitter plus TTY OUT+ ( TxD+) 13

Transmitter minus TTY OUT- ( TxD-) 25

Data Set Ready plus DSR+ 14

Data Set Ready minus DSR- 18

Data Terminal Ready plus RDRCTL+ 16

Data Terminal Ready minus RDRCTL- 21

To make PG1/PG2-Interface TTY aktiv, connect the pin 9 with the pin 10.

16.3 PG-MUX-II for MITSUBISHI

AG-Interface

The Multiplexer should be connected with a 1:1 cable to the Mitsubishi FX, A PLC.

Signalname Notation Pin

Receiver plus RxD+ 3

Receiver minus RxD- 16

Transmitter plus TxD+ 2

Transmitter minus TxD- 15

Request To Send plus RTS+ 4

Request To Send minus RTS- 17

Clear To Send plus CTS+ 5

Clear To Send minus CTS- 18

Current supply +5VDC input +5V 12

Current supply +5VDC input +5V 13

Current supply +5VDC input +5V 24

Current supply +5VDC input +5V 25

Internal ground input Ground 7

Internal ground input Ground 8

Ident1 0V 20

Ident2 PWE\ 21

The pins 20, 21 are bridged in the Multiplexer.