Specifications

9
Error Messages Section 1-6
1.6 Error Messages
Code 1 E SLAVE NOT READY ..........Slave not ready
2E
PROTOKOL ....................Sequence of the packets
3E
FRAME .........................Protocol frame error
4E
TIMEOUT.......................Timeout error
6E
PARITY.........................Parity error
7E
SEND ABORT .................Send process aborted
8E
REC ABORT ...................Receive process aborted
9E
BUF SIZE......................Insufficient cyclic buffer
10 E
NO DEFINE....................No cyclic data defined
12 E
DEFINE ........................Cyclic data already defined
15 E
NO PROTOCOL ...............Selected protocol is not sup-
ported
16 E
OVERRUN......................Receive buffer overrun
17 E
NAK............................NAK from PLC despite repeti-
tion
40 E
SYS ADDRESS ................Undefined system variable
Siemens-specific error messages
50 E
BST RANGE ...................Address outside of the range of
the data block
51 E
RECEIVE COUNT..............Number of data received is in-
correct
52 E
FUN NOT KNOWN ............Unknown function
53 E
WRONG MODE................Wrong mode of operation
54 E
DATA BLOCK NOT KNOWN. .Data block does not exist
55 E
HIGH LEVEL...................Communication has reached
higher level
56 E
LOW LEVEL ...................Communication has reached
lower level
57 E
MESSAGE CONNECT .........Invalid feedback received from
the PLC during the connection
setup phase
58 E
MESSAGE TRANSFER ........Invalid feedback received from
the PLC during the transfer
phase
59 E
MESSAGE DISCONNECT......Invalid feedback received from
the PLC during the disconnect
phase
60 E
CPU TYP 921.................A CPU of the type 921 has been
detected. The operating termi-
nal does not support this CPU
type.
61 E
WRONG ADDR ................Wrong addressing used for job.
The requested address level is
not fully available.