Specifications

57
Error Messages Section 5-13
5.13 Error Messages
These error messages are displayed on the terminal.
Code 1 E
SLAVE NOT READY .......Slave not ready, no connection
2E
PROTOKOL .................Invalid character, no repetition
3E
FRAME ......................Byte frame error, despite repetition
4E
TIMEOUT....................Timeout error
5E
CRC BCC...................CRC error, despite repetition
6E
PARITY......................Parity error, despite repetition
7E
SEND ABORT...............Abort send process
8E
REC ABORT ................Abort receive process
9E
BUF SIZE ...................Insufficient cyclic buffer
10 E
NO DEFINE .................No cyclic data defined
11 E
DEFINE......................Cyclic data already defined
15 E
NO PROTOCOL.............Protocol is not supported
16 E
OVERRUN...................Overrun
40 E
SYS ADDRESS .............Undefined system variable
50 E
QUITTUNG OPEN ..........Invalid acknowledge during com-
munication setup
51 E
QUITTUNG DATA...........Invalid acknowledge after trans-
mission of data
52 E
NO RESPONSE.............No response message
53 E
RECEIVE COUNT...........Incorrect number of data received
Errors which are transmitted by the programming controller (PU) via the response
message.
61 E
NO AG
10 from PU .................No connection to PU
62 E
WRONG ORDER
16 from PU .................Invalid command in message
header
63 E
INV DEST
20 from PU .................Invalid destination has been ad-
dressed
64 E
KOO MERKER SET
50 from PU .................Coordination flag is still set
65 E
SEND COUNT
52 from PU .................Number of data transmitted does
not comply with the specification in
the message header
66 E
SYNCH
54 from PU .................Awaiting response message
70 E
AG...........................The subcode contains the error
which is transmitted in the re-
sponse message by the PLC