Specifications

71
Error Messages Section 7-6
Bosch-specific error messages
50 E
QUITTUNG START ............No communication setup
51 E
QUITTUNG OPEN .............Incorrect acknowledge signal
during communication setup
52 E
QUITTUNG DATA..............Incorrect acknowledge signal to
transmitted information block
53 E
NO RESPONSE WRONG
CHAR .............................No response message
54 E
TIMEOUT NO RESPONSE . . . .Timeout - no response mes-
sage
55 E
TIMEOUT BLOCKZEIT .........Timeout - block time has been
exceeded
56 E
TIMEOUT QUIT RESPONSE . .Timeout - no acknowledge sig-
nal
57 E
ABBRUCH SPS................EOT -PLC abort
58 E
RECEIVE COUNT..............Number of received data is in-
correct
PLC-Error
62 E
WRONG ORDER
32 from the PLC ...............write access to T, C, to module
not permitted
67 E
WRONG PARAMETER
37 from the PLC ...............incorrect parameter
68 E
CHAR COUNT
38 from the PLC ...............number of bytes received is in-
correct accordance with the
message header
69 E
SYSTEM
39 from the PLC ...............incorrect P1 in the system
message
71 E
DIRECTION
41 from the PLC ...............direction not defined
72 E
DB SHORT
42 from the PLC ...............DB too small
74 E
DB NOT PROG
44 from the PLC ...............DB not programmed
76 E
DB NOT DEF
46 from the PLC ...............DB not defined
78 E
WRONG TYP
48 from the PLC ...............block type unknown
79 E
P2 NULL
49 from the PLC ...............parameter 2 is 0
94 E
TELE TYP
64 from the PLC ...............message type incorrect