HC411520GB EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • Do not store items on the cooking surfaces. • Do not use a steam cleaner to clean the appliance. • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. • If the glass surface is cracked, switch off the appliance to avoid the possibility of electric shock. 2.
ENGLISH • Make sure that a shock protection is installed. • Use the strain relief clamp on cable. • Make sure not to cause damage to the mains plug (if applicable) or to the mains cable. Contact the Service or an electrician to change a damaged mains cable. • The electrical installation must have an isolation device which lets you disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm.
www.aeg.com • • • • • • • • er purposes, as for example room heating. The use of a gas cooking appliance results in the production of heat and moisture. Provide good ventilation in the room where the appliance is installed. Make sure that the ventilation openings are not blocked. Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a window, or more effective ventilation, for example increasing the level of mechanical ventilation where present.
ENGLISH 7 3. PRODUCT DESCRIPTION 3.1 Built-in Gas Hob Class 3 General overview 1 1 Burner (minimum pot size = 220 mm) 2 Glass bar 3 Control knob 2 3 3.2 Control knob Symbol Symbol Description minimum gas supply Description no gas supply / off position ignition position / maximum gas supply 4. DAILY USE WARNING! Refer to the Safety chapters. 4.1 Ignition of the burner WARNING! Be very careful when you use open fire in kitchen environment.
www.aeg.com 1 2 4 3 1 Burner cap 2 Burner crown 3 Ignition candle 4 Thermocouple WARNING! Always turn the flame down or switch it off before removing the pans off the burner. 4.3 Using the Wok Stand A wok stand is provided to let you to use a round bottomed wok on the hob. You must only use the wok stand on the Dual Burner and you must not use it with any other type of wok or pan. When you fit the wok stand, make sure the recesses in the frame fit securely on the bars of the pan supports.
ENGLISH • When the liquid starts to boil, turn down the flame to barely simmer the liquid. WARNING! Cookware must not enter the control zone. 9 Make sure pots do not protrude over the edges of the cooktop and that they are centrally positioned on the rings in order to obtain lower gas consumption. Do not place unstable or deformed cookware on the ring. 6. CARE AND CLEANING WARNING! Switch the appliance off and let it cool down before you clean it.
www.aeg.com 7. TROUBLESHOOTING Problem Possible cause There is no spark when lighting the gas Remedy • There is no electrical supply • Make sure that the unit is connected and the electrical supply is switched on. • Control the fuse. If the fuse is released more than one time, refer to a qualified electrician. • Burner cap and crown are placed uneven • Make sure that the burner cap and crown are in correct positions.
ENGLISH WARNING! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. 8.1 Gas Connection Make sure that during the installation the appliance is not connected to electrical supply. Disconnect the mains plug or deactivate the fuses. Disconnect the mains gas supply. Make sure that there is a stop tap assembled between the gas supply of house and the appliance.
www.aeg.com 4. – the fastening clamps are not rusted; – expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. Assemble the parts, follow the same procedure backwards. 5. Replace the rating label (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this label in the package of the injectors supplied with the appliance. When installation is complete, make sure that the seal of each pipe fitting is correct.
ENGLISH 8.4 Electrical connection • Ground the appliance according to safety precautions. • Make sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. • This appliance is supplied with a mains cable. • Any electrical component must be installed or replaced by the Service Force Centre technician or qualified service personnel. • Always use a correctly installed shockproof socket.
www.aeg.com min. 30 mm min. 20 mm • Seal the gap between the worktop and glass ceramic with silicone. • Put some soapy water on the silicone. • Pull off the excess silicone with the scraper. Only use special a heat - resistant silicon. The worktop cut out Distance from the wall : minimum 50 mm Depth : 490 mm Width : sum widths of all the appliances to be built-in and subtract 20 mm (see also "Overview of all appliance widths" ) Example : 8.
ENGLISH front ends of the appliances are on the same level. 15 10. Put some soapy water on the silicon. 11. Press the rubber shape with some strength against the glass ceramic and move it slowly along the space. 12. Do not touch the silicon until it be- come hard, it can last about a day. 8. Tighten the fixing plate / retaining grip screws. 9. Seal the gap between the worktop and appliances and between appliances with silicone. 13. Carefully remove silicon that came out with a shaving blade. 14.
www.aeg.com Exclusions • Damage, calls resulting from transport, improper use, neglect, light bulbs, removable parts of glass, plastic. • Costs for calls to put right appliance which is improperly installed, calls to appliances outside United Kingdom. • Appliances found to be in use within a commercial environment, plus those which are subject to rental agreements. • Products of Electrolux manufacturer that are not marketed by Electrolux Service and Spare Parts.
ENGLISH 17 The provisions of this European Guarantee do not affect any of the rights granted to you by law. 12. WWW.ELECTROLUX.COM Albania +355 4 261 450 Rruga “Kavajës”, ish-parku autobuzëve, Tiranë Belgique/België/Belgien +32 2 7162444 Raketstraat 40, 1130 Brussel/ Bruxelles Česká Republika +420 261 302 261 Budějovická 3, Praha 4, 140 21 Danmark +45 70 11 74 00 Strevelinsvej 38-40, 7000 Fredericia Deutschland +49 180 32 26 622 Fürther Str.
www.aeg.com Polska +48 22 43 47 300 ul. Kolejowa 5/7, 01–217 Wars‐ zawa Portugal +35 12 14 40 39 39 Quinta da Fonte - Edifício Gonçalves Zarco - Q 35 -2774-518 Paço de Arcos Romania +40 21 451 20 30 Str. Garii Progresului 2, S4, 040671 RO Schweiz - Suisse Svizzera 0848 848 111 Industriestrasse 10, CH-5506 Mägenwil Slovenija +38 61 24 25 731 Gerbičeva ulica 110, 1000 Ljubl‐ jana Slovensko +421 2 32 14 13 34-5 Electrolux Slovakia s.r.o.
ENGLISH 19
892934848-F-212013 www.aeg.
