HC412000GB EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • Do not store items on the cooking surfaces. • Do not use a steam cleaner to clean the appliance. • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. • If the glass surface is cracked, switch off the appliance to avoid the possibility of electric shock. 2.
ENGLISH • Make sure that a shock protection is installed. • Use the strain relief clamp on cable. • Make sure not to cause damage to the mains plug (if applicable) or to the mains cable. Contact the Service or an electrician to change a damaged mains cable. • The electrical installation must have an isolation device which lets you disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm.
www.aeg.com • • • • • • • • er purposes, as for example room heating. The use of a gas cooking appliance results in the production of heat and moisture. Provide good ventilation in the room where the appliance is installed. Make sure that the ventilation openings are not blocked. Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a window, or more effective ventilation, for example increasing the level of mechanical ventilation where present.
ENGLISH 7 3. PRODUCT DESCRIPTION 3.1 Built-in Gas Hob Class 3 Cooking surface layout 1 1 Rapid burner (pot size: 2 3 140mm-240mm) 2 Semi rapid burner (pot size: 160mm-240mm) 3 Glass bar 4 Control knobs 4 3.2 Control knob Symbol Symbol Description minimum gas supply Description no gas supply / off position ignition position / maximum gas supply 4. DAILY USE WARNING! Refer to the Safety chapters. 4.1 Ignition of the burner WARNING! Be very careful when you use open fire in kitchen environment.
www.aeg.com 1 In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. 2 If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute.
ENGLISH 9 6. CARE AND CLEANING WARNING! Switch the appliance off and let it cool down before you clean it. Disconnect the appliance from the electrical supply, before carrying out any cleaning or maintenance work. WARNING! For safety reasons, do not clean the appliance with steam cleaners or high-pressure cleaners. WARNING! Do not use abrasive cleaners, steel wool pads or acids, they can cause damage to the appliance. You can remove the pan supports to easily clean the hob.
www.aeg.com 7. TROUBLESHOOTING Problem Possible cause There is no spark when lighting the gas Remedy • There is no electrical supply • Make sure that the unit is connected and the electrical supply is switched on. • Control the fuse. If the fuse is released more than one time, refer to a qualified electrician. • Burner cap and crown are placed uneven • Make sure that the burner cap and crown are in correct positions.
ENGLISH WARNING! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. 8.1 Gas Connection Make sure that during the installation the appliance is not connected to electrical supply. Disconnect the mains plug or deactivate the fuses. Disconnect the mains gas supply. Make sure that there is a stop tap assembled between the gas supply of house and the appliance.
www.aeg.com – the fastening clamps are not rusted; – expired term is not due. If one or more defects are visible, do not repair the pipe, but replace it. injectors supplied with the appliance. 8.3 Adjustment of minimum level When installation is complete, make sure that the seal of each pipe fitting is correct. Use a soapy solution, not a flame! To adjust the minimum level of the burners: 1. Light the burner. 2. Turn the knob on the minimum position. 3. Remove the knob. 4.
ENGLISH • Make sure that there is an access to the mains plug after installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • The appliance must not be connected with an extansion cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. • The power cable must be placed in such a way that it does not touch any hot part.
www.aeg.com min. 30 mm min. 20 mm • Seal the gap between the worktop and glass ceramic with silicone. • Put some soapy water on the silicone. • Pull off the excess silicone with the scraper. Only use special a heat - resistant silicon. The worktop cut out Distance from the wall : minimum 50 mm Depth : 490 mm Width : sum widths of all the appliances to be built-in and subtract 20 mm (see also "Overview of all appliance widths" ) Example : 8.
ENGLISH 7. Put the subsequent appliance in the worktop cut out . Make sure that the front ends of the appliances are on the same level. 15 10. Put some soapy water on the silicon. 11. Press the rubber shape with some strength against the glass ceramic and move it slowly along the space. 12. Do not touch the silicon until it be- come hard, it can last about a day. 13. Carefully remove silicon that came out with a shaving blade. Tighten the fixing plate / retaining grip screws. 9.
www.aeg.com pered with by person not authorised by us. • Electrolux Service Force Centre must undertake all service work under this guarantee • Any appliance or defective part replaced shall become the Company's property. • This guarantee is in addition to your statutory and other legal rights. Exclusions • Damage, calls resulting from transport, improper use, neglect, light bulbs, removable parts of glass, plastic.
ENGLISH • The appliance guarantee is personal to the original purchaser of the appliance and cannot be transferred to another user. • The appliance is installed and used in accordance with instructions issued by Electrolux and is only used within the home, i.e. is not used for commercial purposes. 17 • The appliance is installed in accordance with all relevant regulations in force within your new country of residence.
www.aeg.com Nederland +31 17 24 68 300 Vennootsweg 1, 2404 CG - Alphen aan den Rijn Norge +47 81 5 30 222 Risløkkvn. 2 , 0508 Oslo Österreich 0810 955030 Herziggasse 9, 1230 Wien Polska +48 22 43 47 300 ul. Kolejowa 5/7, 01–217 Wars‐ zawa Portugal +35 12 14 40 39 39 Quinta da Fonte - Edifício Gonçalves Zarco - Q 35 -2774-518 Paço de Arcos Romania +40 21 451 20 30 Str.
ENGLISH 19
892934850-E-212013 www.aeg.