User manual

If you tried the above solutions and cannot repair the problem, speak to your dealer or the
Customer Care Department. Give the data from the rating plate, three-digit-letter code for
the glass ceramic (it is in the corner of the cooking surface) and an error message that
comes on.
If you operated the appliance incorrectly, the servicing by a customer service technician or
dealer will not be free of charge, even during the warranty period. The instructions about
the customer service and conditions of guarantee are in the guarantee booklet.
INSTALLATION
WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, record the information below from the rating plate.
The rating plate is on the bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you assemble the appliance into correct built-in
units and work surfaces that align to the standards.
Connection cable
• The appliance is supplied with the connection cable.
• Replace the damaged mains cable with a special cable (type H05BB-F Tmax 90°C; or
higher). Speak to your local Service Centre.
To attach the seal.
• Clean the worktop in the area of the cut out section.
• Bond the seal stripe supplied on the lower edge of the appliance along the outer edge of
the glass ceramic. Do not extend it. Let stay the cut ends in the middle of one side.
When, you cut it to length (add some mm), push the two ends together.
Installation
37