DM 8700 - DM 8600 DM 8400 - DD 8770 HD 6470 Dunstabzugshaube Afzuigkap Hotte aspirante Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions
Contents Safety warnings For the user For the installer 65 65 65 Description of the Appliance Extraction Recirculation 67 67 67 Control Panel - Model DM 8700 - DD 8770 Switching on the hood Switching on the light Control device for grease or charcoal filter Led signal for grease filter Led signal for charcoal filter Re-setting the saturation signal 68 69 69 69 69 69 69 Control Panel - Model DM 8600 Control device for grease and charcoal filters Grease filter LED (D) Charcoal filter LED (E) Resetting t
Safety warnings For the user The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control. The hot oil in the frying pan might ignite due to overheating.
The national standard on fuel-burning systems specifies a maximum depression of 0.04 bar in such rooms. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. The air outlet installation must comply with the regulations laid down by the relevant authorities.
Description of the Appliance coupling ring The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extraction In this version fumes are extracted to the outside via a hose connected to the coupling ring. Fig. 1. Fig. 1 In order to obtain the best performance the hose should have a diameter equal to the outlet hole.
Control Panel Model DM 8700 - DD 8770 Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared.
Hood Operation - Model DM 8700 - DD 8770 Switching on the hood - Fig. 3 The control ball is a balancer switch. Depressing the control ball repeatedly towards the right switches on the hood and you may select the suction level desired, depressing once again on the right the hood switches off. Switching on the light - Fig. 3 Depress the control ball towards the left : once for submersed lighting, once again for full lighting, depress again to switch off the light.
Control Panel Model DM 8600 Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the units front panel: A B C D E - F G - H I - A Main switch, hood off.
Control device for grease and charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the charcoal filter (in the case of recirculation version with charcoal filter). On delivery, the hood is not supplied with an charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Press buttons B and G simultaneously and hold them for 3 seconds.
Control Panel Model DM 8400 - HD 6470 Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared.
Maintenance and care The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Never insert pointed objects in the motors protective grid. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders.
Charcoal filter The charcoal filter should only be used if you want to use the hood in the recirculation function. To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage).
Warning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a lever.
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working effectively.. Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air.
Technical assistance service (not for UK) You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. For service in Australia call 1300 650 020. When calling, please be ready to specify: 1. The model code number 2. The serial number (E-Nr.) 3. The manufacturing number (F-Nr.) This information is shown on the registration plate inside the unit behind the grease filter.
Technical Specifications Models DM 8600 HD 6470 Dimensions* - extractor version (in cm): Height 66-112 Dimensions* - filter version (in cm): Height 75,5-122 Maximum absorbed power: 210 W Motor absorption: 1 x 170 W Lighting: 2 x 20W Lenght of the cable: 150 cm Electrical connection: 220-240 V DM 8700 DD 8770 DM 8400 70-113 66-112 78-122 75,5-122 210 W 1 x 170 W 2 x 20W 150 cm 220-240 V 210 W 1 x 160 W 2 x 20W 150cm 230 V * Width and depth depend on the glass body which is installed with the cooker
Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board.
Wall unit mounting - Fig. 7 First decide which functioning version is better for you. If you decide to use the hood in exhausting version we suggest to position the upper section of the chimney so that the oulet slots are not visible once installation has ended, on the contrary if is decided to use the hood in recycling version BE SURE that the side with slots is up (see also A-BC sequence on on Fig. 7).
Wall unit mounting - Fig. 8 Only for DD 8770 and HD 6470: Assemble the frame to the motor group (a - Fig. 8.1). Connect lamps and control panel to the motor housing (b - Fig. 8.1). Fix the frame to the motor group using 2 screws (c - Fig. 8.1).
a b c Fig. 8.1 10 15b 11 G 15b B 15a 180° 15a H F A 16a 1 4 16a 12 3 13 2 6 5-6 D 5 8 5-6 16b 14 7 14 Fig.
Sonderzubehör/Wrasenschirm Extra leverbare accessoires/Dampscherm Accessoires/Séparateur de vapeur Special accessories/Vapour screen SM 8090 E-Nr. 942 120 654 89,9 50 89,8 50 89.9 50 SM 8091 E-Nr. 942 120 655 SM 8092 E-Nr. 942 120 656 89.8 50 SM 8093 E-Nr. 942 120 657 105-85 50.3 SM 8010 E-Nr. 942 120 743 SM 8005 E-Nr. 942 120 746 SM 8085 (88cm) - E-Nr. 942 120 744 SM 8065 (60 cm) - E-Nr.
From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de http://www.aeg.co.