User manual

Wall unit mounting - Fig. 7-8

 Assembling the chimney flue support/

bracket:

The three parts should be fixed with 4

screws, the support extension is

adjustable and should correspond to the

internal width of the telescopic chimney

flue. Fig. 6.

 Mark the wall with a centre line, this will

aid mounting procedure (1), position the

template so that the mid line printed on

the template matches with the centre line

previously drawn, the lower side of the

template corresponds to the lower side of

the hood once mounted (2).

 Drill two holes Ø 8mm and fix the support

bracket with two wall plugs and screws

(3). Hang the hood (4) and adjust its

position (5-6).

 From the inside of the hood sign two

points for definitive fixing (7).

 Remove the hood (8) and drill two holes Ø 8mm (9), fit two wall

plugs (10).

 Drill two holes Ø 8mm on the upper side close to the ceilling, fit two

wall plugs (11) (In case the hood is to be used in filter version,

mount the deflector F on the chimney support with four screws

2,9x6,5 and fix the chimney support G with two screws (12).

 Hang the hood again (13) and fix it definitively with two screws (14).

 Fit an exhausting pipe (15) to connect the outlet hole A of the hood

to the outside (Extractor hood) or to the deflector F (Filter version).

 Make electrical connection (16).

 Fix the chimney first up (17a) to the chimney support (17b), then

slide the lower section of the chimney down into the proper housing

on top of the hood (18).

Fig. 7