HD955100NB EN User Manual
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 7 4. DAILY USE...................................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • • • • • Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance. After use, switch off the hob element by its control and do not rely on the pan detector.
ENGLISH • Obey the installation instruction supplied with the appliance. • Keep the minimum distance from the other appliances and units. • Always be careful when you move the appliance because it is heavy. Always wear safety gloves. • Seal the cut surfaces with a sealant to prevent moisture to cause swelling. • Protect the bottom of the appliance from steam and moisture. • Do not install the appliance adjacent to a door or under a window.
www.aeg.com • This appliance is not connected to a device, which evacuates the products of combustion. Make sure to connect the appliance according to current installation regulations. Pay attention to requirements regarding adequate ventilation. 2.4 Use WARNING! Risk of injury, burns and electrical shock. • Remove all the packaging, labelling and protective film (if applicable) before first use. • Use this appliance in a household environment. • Do not change the specification of this appliance.
ENGLISH 2.5 Care and cleaning • Clean regularly the appliance to prevent the deterioration of the surface material. • Deactivate the appliance and let it cool down before you clean it. • Disconnect the appliance from the electrical supply before maintenance. • Do not use water spray and steam to clean the appliance. • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
www.aeg.com 3.3 Control panel layout 1 2 10 3 4 9 8 5 7 6 Use the sensor fields to operate the appliance. The displays, indicators and sounds tell which functions operate. Sensor field Function Comment 1 ON / OFF To activate and deactivate the hob. 2 Lock / The Child Safety Device To lock / unlock the control panel. - Timer indicators of cooking zones To show for which zone you set the time. - Timer display To show the time in minutes.
ENGLISH Display 9 Description Power function operates. + digit There is a malfunction. / OptiHeat Control (3 step Residual heat indicator) : continue cooking / keep warm / residual heat. / Lock / The Child Safety Device function operates. Incorrect or too small cookware or no cookware on the cooking zone. Automatic Switch Off function operates. 3.5 OptiHeat Control (3 step Residual heat indicator) WARNING! / / There is a risk of burns from residual heat.
www.aeg.com lets the thermocouple warm up. If not, the gas supply is interrupted. 3. Adjust the flame after it is regular. If after some tries the burner does not light, check if the crown and its cap are in correct positions. Using the wok stand The wok stand lets you use a round bottomed wok on the hob. Use the wok stand on the Dual burner only. When you refit the wok stand, make sure the recesses on the frame fit securely to the bars of the pan supports.
ENGLISH 11 • You do not deactivate a cooking zone or change the heat setting. After To activate the function for a cooking some time comes on and the hob deactivates. See below. The relation between heat setting and times of the function: To deactivate the function: change the heat setting. , 1 — 3 — 6 hours • • 4 — 7 — 5 hours • 8 — 9 — 4 hours • 10 — 14 — 1.5 hours Count Down Timer You can use this function to set how long the cooking zone operates for only this one time.
www.aeg.com To activate the function: touch of the timer. comes on. When the indicator of the cooking zone starts to flash slowly the time counts up. The display switches between counted time (minutes). and To see how long the cooking zone operates: set the cooking zone with . The indicator of the cooking zone starts to flash quickly. The display shows how long the zone operates. To deactivate the function: set the cooking zone with and touch or . The indicator of the cooking zone goes out.
ENGLISH • • • • you touch Minute Minder comes down Count Down Timer comes down you put something on the control panel. 13 • The function decreases the power to the other cooking zones connected to the same phase. • The heat setting display of the reduced zones changes between two levels. Power management function • Cooking zones are grouped according to the location and number of the phases in the hob. See the illustration. • Each phase has a maximum electricity loading of 3700 W.
www.aeg.com CAUTION! Make sure that the bottoms of pots do not stand above the control knobs, otherwise the flame heats the control knobs up. CAUTION! Make sure that pot handles are not above the front edge of the cooktop. CAUTION! Make sure that the pots are placed centrally on the burners in order to get maximum stability and to get lower gas consumption. CAUTION! Liquids spilt during cooking can cause the glass to break. 5.
ENGLISH 15 Heat setting Use to: Time (min) Hints 1-3 Hollandaise sauce, melt: butter, chocolate, gelatine. 5 - 25 Mix from time to time. 1-3 Solidify: fluffy omelettes, baked eggs. 10 - 40 Cook with a lid on. 3-5 Simmer rice and milkbased dishes, heating up readycooked meals. 25 - 50 Add the minimum twice as much liquid as rice, mix milk dishes part procedure through. 5-7 Steam vegetables, fish, meat. 20 - 45 Add some tablespoons of liquid. 7-9 Steam potatoes. 20 - 60 Use max.
www.aeg.com supports are aligned with the centre of the burner. soapy water and dry them carefully before you put them back. 6.3 Cleaning the hob 6.4 Cleaning the spark plug • Remove immediately: melted plastic, plastic foil, and food with sugar. If not, the dirt can cause damage to the hob. Put the special scraper on the glass surface at an acute angle and move the blade on the surface.
ENGLISH Problem Possible cause 17 Remedy An acoustic signal sounds You put something on one and the hob deactivates. or more sensor fields. An acoustic signal sounds when the hob is deactivated. Remove the object from the sensor fields. The hob deactivates. Remove the object from the sensor field. You put something on the sensor field . Residual heat indicator does not come on. The zone is not hot because If the zone operated suffiit operated only for a short ciently long to be hot, speak time.
www.aeg.com Problem and a number come on. Possible cause Remedy There is an error in the hob. Disconnect the hob from the electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect it again. If comes on again, speak to an Authorised Service Centre. comes on. There is an error in the hob because a cookware boils dry. Automatic Switch Off and the overheating protection for the zones operate.
ENGLISH 19 conditions of guarantee are in the guarantee booklet. 7.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C MOD. PROD.NO. SER.NO. 0049 TYPE 230V-50Hz IP20 03 IT MADE IN ITALY A) Stick it on Guarantee Card and send this part (if applicable). B) Stick it on Guarantee Card and keep this part (if applicable). C) Stick it on instruction booklet. 8.
www.aeg.com The hob should not be installed in a bed sitting room with a volume of less than 20 m³. If it is installed in a room of volume less than 5 m³ an air vent of effective area of 100 cm² is required. If it is installed in a room of volume between 5 m³ and 10 m³ an air vent of effective area of 50 cm² is required, while if the volume exceeds 11 m³ no air vent is required.
ENGLISH CAUTION! Make sure that the gas supply pressure of the appliance obeys the recommended values. Rigid connection: Carry out connection by using metal rigid pipes (copper with mechanical end). 8.5 Injectors replacement 1. Remove the pan supports. 2. Remove the caps and crowns of the burner. 3. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in "Technical Information" chapter).
www.aeg.com of clamps fixed to the side of the cabinet, in order to avoid any contact with the equipment beneath the cooktop. Electrical Requirements Permanent electrical installation must agree with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety the installation must be done by a qualified electrician (e.g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting [NICEIC]).
ENGLISH phase. There must be no cut or stray strands of wire present. The cord clamp must be correctly attached to the outer sheath. 8.9 Attaching the seal 1. Clean the worktop around the cut out area. 2. Attach the supplied seal stripe to the lower edge of the hob along the outer edge of the glass ceramic. Do not extend it. Make sure that the ends of the seal stripe are located in the middle of one side of the hob. 3. Add some mm when you cut the seal stripe to the length. 4.
www.aeg.com min. 38 mm min. 2 mm R 5 mm 600 mm 490 mm 830 mm min. 55 mm min. 12 mm min. 2 mm CAUTION! Install the appliance only on a worktop with a flat surface. 8.11 Possibilities for insertion Kitchen unit with door The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary. min. 30 mm a min. 60 mm min.
ENGLISH 25 safety reasons and to let easy remove oven from the unit. If you install the hob asymmetrically rightward the minimum distance between left edge of the hob and left support must be 72 mm. min. 72 mm 9. TECHNICAL INFORMATION 9.1 Hob dimensions Width 880 mm Depth 520 mm 9.
www.aeg.com Electric supply: 230 V ~ 50 Hz Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 9.5 Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW MINIMUM POWER kW INJECTOR MARK 1/100 mm Dual 5,0 1,42 70 / 115 Dual (internal crown) 0,8 0,33 70 9.
ENGLISH 27
867305016-A-112014 www.aeg.
