HG654550 USER MANUAL FR Notice d'utilisation Table de cuisson
www.aeg.com TABLE DES MATIÈRES 1. INFORMATIONS DE SÉCURITÉ.................................................................................2 2. CONSIGNES DE SÉCURITÉ........................................................................................5 3. DESCRIPTION DE L'APPAREIL...................................................................................8 4. UTILISATION QUOTIDIENNE.................................................................................... 8 5. CONSEILS................
FRANÇAIS 3 utilisation. Conservez toujours les instructions dans un lieu sûr et accessible pour vous y référer ultérieurement. 1.
www.aeg.com • • • • • • • • • sur une table de cuisson car cela pourrait provoquer un incendie. N'essayez JAMAIS d'éteindre un feu avec de l'eau. Éteignez l'appareil puis couvrez les flammes, par exemple avec un couvercle ou une couverture ignifuge. ATTENTION : Toute cuisson doit être surveillée. Une cuisson courte doit être surveillée en permanence. AVERTISSEMENT : Risque d'incendie ! N'entreposez rien sur les surfaces de cuisson.
FRANÇAIS 5 2. CONSIGNES DE SÉCURITÉ Cet appareil est adapté aux marchés suivants: FR 2.1 Installation AVERTISSEMENT! L'appareil doit être installé uniquement par un professionnel qualifié. • Retirez l'intégralité de l'emballage. • N'installez pas et ne branchez pas un appareil endommagé. • Suivez scrupuleusement les instructions d'installation fournies avec l'appareil. • Respectez l'espacement minimal requis par rapport aux autres appareils et éléments.
www.aeg.com • Ne tirez jamais sur le câble d'alimentation pour débrancher l'appareil. Tirez toujours sur la fiche. • N'utilisez que des systèmes d'isolation appropriés : des coupecircuits, des fusibles (les fusibles à visser doivent être retirés du support), un disjoncteur différentiel et des contacteurs. • L'installation électrique doit être équipée d'un dispositif d'isolement à coupure omnipolaire. Le dispositif d'isolement doit présenter une distance d'ouverture des contacts d'au moins 3 mm. 2.
FRANÇAIS • Utilisez uniquement des récipients stables ayant une forme adaptée et un diamètre supérieur à celui des brûleurs. • Assurez-vous que les récipients sont placés au centre des brûleurs. • Assurez-vous que la flamme ne s'éteint pas lorsque vous tournez rapidement la manette de la position maximale à la position minimale. • N'utilisez que les accessoires fournis avec l'appareil. • N'installez pas de diffuseur de flamme sur le brûleur.
www.aeg.com 3. DESCRIPTION DE L'APPAREIL 3.1 Description de la table de cuisson 1 1 2 3 4 2 Brûleur semi-rapide Brûleur à triple couronne Brûleur auxiliaire Manettes de commande 3 4 3.2 Manette de commande Symbole Symbole Description Description alimentation en gaz minimale pas d'alimentation en gaz / position Arrêt position d'allumage / alimentation en gaz maximale 4. UTILISATION QUOTIDIENNE AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. A 4.
FRANÇAIS 4.2 Allumage du brûleur Allumez toujours le brûleur avant de poser un récipient dessus. AVERTISSEMENT! Faites très attention lorsque vous utilisez une flamme nue dans une cuisine. Le fabricant décline toute responsabilité en cas de mauvaise utilisation de la flamme. 1. Enfoncez la manette et tournez-la vers la gauche jusqu'à la position d'arrivée de gaz maximale ( ). 2. Maintenez la manette enfoncée pendant 10 secondes environ. Cela permet au thermocouple de chauffer.
www.aeg.com 5.1 Ustensiles de cuisson ATTENTION! Assurez-vous que les récipients de cuisson sont bien centrés sur le brûleur afin de garantir leur stabilité et de réduire la consommation de gaz. ATTENTION! N'utilisez pas de plats en fonte, en stéatite, en grès, de grils ou de plats à gratin. L'acier inoxydable peut ternir s'il est trop chauffé. AVERTISSEMENT! Ne placez pas le même récipient sur deux brûleurs.
FRANÇAIS 11 détachants ou anti-rouille, ni avec des produits de nettoyage par immersion. 6.2 Supports de casserole Les supports de casserole ne sont pas adaptés au lavage dans un lave-vaisselle. Ils doivent être lavés à la main. 1. Retirez les supports de casserole pour nettoyer facilement la table de cuisson. Replacez les supports de casserole avec soin afin de ne pas endommager le dessus de la table de cuisson. 2.
www.aeg.com tuyau d'arrivée de gaz et du régulateur de pression si votre installation en est équipée. 7. EN CAS D'ANOMALIE DE FONCTIONNEMENT AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 7.1 En cas d'anomalie de fonctionnement Anomalie Cause possible Solution Aucune étincelle ne se produit lorsque vous tentez d'actionner le générateur d'étincelles. La table de cuisson n'est pas connectée à une source d'alimentation électrique ou le branchement est incorrect.
FRANÇAIS 13 7.3 Étiquettes fournies dans le sachet des accessoires Collez les étiquettes adhésives comme indiqué ci-dessous : A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C MOD. PROD.NO. SER.NO. 0049 TYPE IP20 03 IT MADE IN ITALY A. Collez-la sur la carte de garantie et envoyez cette partie (le cas échéant). B. Collez-la sur la carte de garantie et conservez cette partie (le cas échéant). C. Collez-la sur la notice d'utilisation. 8.
www.aeg.com Assurez-vous que la pression de l'alimentation en gaz de l'appareil correspond aux valeurs recommandées. Le raccordement réglable est relié à la rampe complète par un écrou fileté G 1/2 po. Vissez les pièces sans forcer, ajustez le raccordement dans le sens souhaité, puis serrez le tout. A B C A. Extrémité du tuyau avec écrou B. Rondelle C.
FRANÇAIS 4. Assemblez les pièces et suivez la même procédure dans l'ordre inverse. 5. Remplacez la plaque signalétique (qui se trouve près du tuyau d'arrivée de gaz) par celle correspondant au nouveau type d'alimentation en gaz. Vous trouverez cette plaque dans le sachet fourni avec l'appareil. Si la pression de l'alimentation en gaz peut être modifiée ou est différente de la pression nécessaire, vous devez monter un système de réglage de la pression sur le tuyau d'arrivée de gaz. 8.
www.aeg.com 8.7 Montage Si un meuble est installé à 400 mm au-dessus de la table de cuisson, vous devez laisser une distance de sécurité minimale de 50 mm à gauche ou à droite du bord de la table de cuisson. 1. 5. 2. 6. 3. 7. min. 100 mm min. 650 mm min. 55 mm 30 mm 480 mm 560 mm 4. 8. 400 mm 50 mm 9.
FRANÇAIS 17 8.8 Possibilités d'insertion A Le panneau installé sous la table de cuisson doit être facile à retirer et facilement accessible au cas où une intervention technique serait nécessaire. Élément de cuisine avec une porte B 10. A) joint fourni B) équerres fournies min 6 mm a 11. b min 30 mm min 5 mm (max 150 mm) 60 mm A. Panneau amovible B. Espace pour les branchements ATTENTION! Installez l'appareil uniquement sur un plan de travail dont la surface est plane.
www.aeg.com BRÛLEUR Ø VIS DE RÉGLAGE 1/100 mm Semi-rapide 42 Auxiliaire 32 9.3 Autres caractéristiques techniques Gaz d'origine : G20/G25 (2E+) 20/25 mbar = 9 kW PUISSANCE TOTALE : Gaz de remplacement : G30 (3+) 28-30 mbar = 654 g/h G31 (3+) 37 mbar = 643 g/h Alimentation électrique : 220-240 V ~ 50/60 Hz Catégorie de l'appareil : II2E+3+ Raccordement au gaz : G 1/2" Classe de l'appareil : 3 9.
FRANÇAIS Type de table de cuisson Table de cuisson intégrée Nombre de brûleurs à gaz 4 Arrière gauche - Semi-rapide Efficacité énergétique selon le brû- Arrière droit - Semi-rapide leur à gaz Avant gauche - Triple couronne (EE gas burner) Avant droit - Auxiliaire Efficacité énergétique de la table de cuisson (EE gas hob) 19 55.2% 55.2% 52.0% non applicable 54.1% EN 30-2-1 : Appareils de cuisson domestiques à gaz - Partie 2-1 : Utilisation rationnelle de l'énergie - Général 10.
867329127-D-422016 www.aeg.