FR Notice d'utilisation Table de cuisson HG694340XB
www.aeg.com TABLE DES MATIÈRES 1. CONSIGNES DE SÉCURITÉ........................................................................................... 3 2. INSTRUCTIONS DE SÉCURITÉ...................................................................................... 5 3. DESCRIPTION DE L'APPAREIL...................................................................................... 8 4. UTILISATION QUOTIDIENNE........................................................................................8 5.
FRANÇAIS 1. 3 CONSIGNES DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne peut être tenu pour responsable des dommages et blessures liés à une mauvaise installation ou utilisation. Conservez toujours cette notice avec votre appareil pour vous y référer ultérieurement. 1.
www.aeg.com • • • • • • • • • • Il peut être dangereux de laisser chauffer de la graisse ou de l'huile sans surveillance sur une table de cuisson car cela pourrait provoquer un incendie. N'essayez jamais d'éteindre un feu avec de l'eau. Éteignez l'appareil puis couvrez les flammes, par exemple avec un couvercle ou une couverture ignifuge. N'entreposez rien sur les surfaces de cuisson.
FRANÇAIS 5 2. INSTRUCTIONS DE SÉCURITÉ Cet appareil est adapté aux marchés suivants: FR 2.1 Instructions d’installation AVERTISSEMENT! L'appareil doit être installé uniquement par un professionnel qualifié. • Retirez l'intégralité de l'emballage • N'installez pas et ne branchez pas un appareil endommagé. • Suivez scrupuleusement les instructions d'installation fournies avec l'appareil. • Respectez l'espacement minimal requis par rapport aux autres appareils et éléments.
www.aeg.com • N'utilisez que des systèmes d'isolation appropriés : des coupecircuits, des fusibles (les fusibles à visser doivent être retirés du support), des disjoncteurs différentiels et des contacteurs. • L'installation électrique doit être équipée d'un dispositif d'isolement à coupure omnipolaire. Le dispositif d'isolement doit présenter une distance d'ouverture des contacts d'au moins 3 mm. 2.3 Raccordement au gaz • Tous les raccordements au gaz doivent être effectués par une personne qualifiée.
FRANÇAIS • • • • • • • • • dont le fond est endommagé et rugueux. Ils risqueraient de rayer le verre ou la surface vitrocéramique. Soulevez toujours ces objets lorsque vous devez les déplacer sur la surface de cuisson. Utilisez uniquement des récipients stables ayant une forme adaptée et un diamètre supérieur à celui des brûleurs. Assurez-vous que les récipients sont placés au centre des brûleurs.
www.aeg.com 3. DESCRIPTION DE L'APPAREIL 3.1 Description de la table de cuisson 1 2 3 1 2 3 4 Brûleur rapide Brûleur auxiliaire Brûleur semi-rapide Manettes de commande 4 3.2 Manette de commande Symbole Symbole Description Description alimentation en gaz minimale pas d'alimentation en gaz / position Arrêt position d'allumage / alimentation en gaz maximale 4. UTILISATION QUOTIDIENNE AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 4.
FRANÇAIS C) Bougie d'allumage 4.2 Allumage du brûleur Allumez toujours le brûleur avant de poser un récipient dessus. AVERTISSEMENT! Faites très attention lorsque vous utilisez une flamme nue dans une cuisine. Le fabricant décline toute responsabilité en cas de mauvaise utilisation de la flamme. 1. Enfoncez la manette et tournez-la vers la gauche jusqu'à la position d'arrivée de gaz maximale ( ). 2. Maintenez la manette enfoncée pendant 10 secondes environ. Cela permet au thermocouple de chauffer.
www.aeg.com 5.1 Ustensiles de cuisson ATTENTION! Assurez-vous que les récipients de cuisson sont bien centrés sur le brûleur afin de garantir leur stabilité et de réduire la consommation de gaz. ATTENTION! N'utilisez pas de plats en fonte, en stéatite, en grès, de grils ou de plats à gratin. AVERTISSEMENT! Ne placez pas le même récipient sur deux brûleurs. AVERTISSEMENT! Ne placez pas de récipients instables ou déformés sur le brûleur afin d'éviter les débordements et les blessures.
FRANÇAIS 6.2 Supports de casserole Les supports de casserole ne sont pas adaptés au lavage dans un lave-vaisselle. Ils doivent être lavés à la main. 1. Retirez les supports de casserole pour nettoyer facilement la table de cuisson. Replacez les supports de casserole avec soin afin de ne pas endommager le dessus de la table de cuisson. 2. Lorsque vous lavez les supports de casserole à la main, faites bien attention lorsque vous les essuyez, car le revêtement en émail peut présenter des bords coupants.
www.aeg.com Problème Cause probable Solution Le fusible a disjoncté. Vérifiez que le fusible est bien la cause de l'anomalie. Si les fusibles disjonctent de manière répétée, faites appel à un électricien qualifié. Le chapeau et la couronne Positionnez correctement le du brûleur sont mal position- chapeau et la couronne du nés. brûleur. La flamme s'éteint immédiatement après s'être allumée. Le thermocouple n'est pas suffisamment chauffé.
FRANÇAIS 13 7.3 Étiquettes fournies dans le sachet des accessoires Collez les étiquettes adhésives comme indiqué ci-dessous : A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C MOD. PROD.NO. SER.NO. 0049 TYPE IP20 03 IT MADE IN ITALY A) Collez-la sur la carte de garantie et envoyez cette partie (le cas échéant). B) Collez-la sur la carte de garantie et conservez cette partie (le cas échéant). C) Collez-la sur la notice d'utilisation. 8.
www.aeg.com Assurez-vous que la pression de l'alimentation en gaz de l'appareil correspond aux valeurs recommandées. Le raccordement réglable est relié à la rampe complète par un écrou fileté G 1/2 po. Serrez les parties sans forcer, ajustez le raccordement dans la direction nécessaire et serrez tout.
FRANÇAIS dans le chapitre « Caractéristiques techniques »). 4. Assemblez les pièces et suivez la même procédure dans l'ordre inverse. 5. Remplacez la plaque signalétique (qui se trouve près du tuyau d'arrivée de gaz) par celle correspondant au nouveau type d'alimentation en gaz. Vous trouverez cette plaque dans le sachet fourni avec l'appareil.
www.aeg.com 8.7 Encastrement min. 450 mm A) joint fourni B) équerres fournies ATTENTION! Installez l'appareil uniquement sur un plan de travail dont la surface est plane. min. 650 mm min. 45 mm +2 490 0mm 40 mm 560+20 mm 8.8 Possibilités d'insertion Le panneau installé sous la table de cuisson doit être facile à retirer et facilement accessible au cas où une intervention technique serait nécessaire.
FRANÇAIS 17 9.3 Autres caractéristiques techniques Gaz d'origine : G20/G25 (2E+) 20/25 mbar =7,7kW PUISSANCE TOTALE : Gaz de remplacement : G30 (3+) 28-30 mbar = 545 g/h G31 (3+) 37 mbar = 536 g/h Alimentation électrique : 230 V ~ 50 Hz Catégorie de l'appareil : II2E+3+ Raccordement au gaz : G 1/2" Classe de l'appareil : 3 9.
www.aeg.com Arrière gauche - Rapide Efficacité énergétique selon le brû- Arrière droit - Semi-rapide leur à gaz Avant droit - Semi-rapide (EE gas burner) Avant gauche - Auxiliaire Efficacité énergétique de la table de cuisson (EE gas hob) 56.0% 61.0% 58.2% non applicable 58.4% EN 30-2-1 : Appareils de cuisson domestiques à gaz - Partie 2-1 : Utilisation rationnelle de l'énergie - Général 10.
FRANÇAIS 19
867305346-A-412014 www.aeg.