FR Notice d'utilisation Table de cuisson HG694840
www.aeg.com TABLE DES MATIÈRES 1. CONSIGNES DE SÉCURITÉ........................................................................................... 3 2. INSTRUCTIONS DE SÉCURITÉ...................................................................................... 5 3. DESCRIPTION DE L'APPAREIL...................................................................................... 8 4. UTILISATION QUOTIDIENNE........................................................................................8 5.
FRANÇAIS 1. 3 CONSIGNES DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne peut être tenu pour responsable des dommages et blessures liés à une mauvaise installation ou utilisation. Conservez toujours cette notice avec votre appareil pour vous y référer ultérieurement. 1.
www.aeg.com • • • • • • • • • • Il peut être dangereux de laisser chauffer de la graisse ou de l'huile sans surveillance sur une table de cuisson car cela pourrait provoquer un incendie. N'essayez jamais d'éteindre un feu avec de l'eau. Éteignez l'appareil puis couvrez les flammes, par exemple avec un couvercle ou une couverture ignifuge. N'entreposez rien sur les surfaces de cuisson.
FRANÇAIS 5 2. INSTRUCTIONS DE SÉCURITÉ Cet appareil est adapté aux marchés suivants: FR 2.1 Instructions d’installation AVERTISSEMENT! L'appareil doit être installé uniquement par un professionnel qualifié. Avant l'installation, vérifiez si les conditions de distribution locale (nature et pression du gaz) sont compatibles avec le réglage de l'appareil. • Retirez l'intégralité de l'emballage • N'installez pas et ne branchez pas un appareil endommagé.
www.aeg.com • Si la prise de courant est lâche, ne branchez pas la fiche d'alimentation secteur. • Ne tirez jamais sur le câble d'alimentation électrique pour débrancher l'appareil. Tirez toujours sur la fiche. • N'utilisez que des systèmes d'isolation appropriés : des coupecircuits, des fusibles (les fusibles à visser doivent être retirés du support), des disjoncteurs différentiels et des contacteurs. • L'installation électrique doit être équipée d'un dispositif d'isolement à coupure omnipolaire.
FRANÇAIS • Prenez soin de ne pas laisser tomber d'objets ou de récipients sur l'appareil. Sa surface risque d'être endommagée. • Ne faites jamais fonctionner les zones de cuisson avec des récipients de cuisson vides ou sans aucun récipient de cuisson. • Ne placez jamais de papier aluminium sur l'appareil. • N'utilisez pas de récipients en fonte ou en aluminium, ni de récipients dont le fond est endommagé et rugueux. Ils risqueraient de rayer le verre ou la surface vitrocéramique.
www.aeg.com 3. DESCRIPTION DE L'APPAREIL 3.1 Description de la table de cuisson 1 2 3 1 2 3 4 Brûleur rapide Brûleur auxiliaire Brûleur semi-rapide Manettes de commande 4 3.2 Manette de commande Symbole Symbole Description Description alimentation en gaz minimale pas d'alimentation en gaz / position Arrêt position d'allumage / alimentation en gaz maximale 4. UTILISATION QUOTIDIENNE AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 4.
FRANÇAIS C) Thermocouple 4.2 Allumage du brûleur Allumez toujours le brûleur avant de poser un récipient dessus. AVERTISSEMENT! N'allumez pas le brûleur quand le répartiteur de flamme est retiré. AVERTISSEMENT! Faites très attention lorsque vous utilisez une flamme nue dans une cuisine. Le fabricant décline toute responsabilité en cas de mauvaise utilisation de la flamme. 1. Enfoncez la manette tout en la tournant vers la gauche jusqu'à la position d'arrivée de gaz maximale ( ). 2.
www.aeg.com 5. CONSEILS AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 5.1 Ustensiles de cuisson ATTENTION! N'utilisez pas de plats en fonte, en stéatite, en grès, de grils ou de plats à gratin. AVERTISSEMENT! Ne placez pas le même récipient sur deux brûleurs. AVERTISSEMENT! Ne placez pas de récipients instables ou déformés sur les brûleurs afin d'éviter les débordements et les blessures.
FRANÇAIS • Les rayures ou les taches sombres sur la surface n'ont aucune incidence sur le fonctionnement de la table de cuisson. • Utilisez un nettoyant spécialement adapté à la surface de la table de cuisson. AVERTISSEMENT! N'utilisez pas de couteau, de grattoir ou d'instruments similaires pour nettoyer les surfaces en verre ou entre les bords des brûleurs et l'encadrement (si présent). 11 supports de casserole en place.
www.aeg.com 6.5 Nettoyage du répartiteur de flamme Vous pouvez laver les répartiteurs de flamme dans un lave-vaisselle. AVERTISSEMENT! Laissez refroidir les répartiteurs de flamme avant de les laver. Légèrement sale : Lavez le répartiteur de flamme avec de l'eau chaude savonneuse, puis séchez-le avec un chiffon doux. Moyennement sale : Utilisez le lave-vaisselle.
FRANÇAIS 13 Problème Cause probable Solution La flamme s'éteint immédiatement après s'être allumée. Le thermocouple n'est pas suffisamment chauffé. Maintenez la manette enfoncée pendant 10 secondes maximum une fois la flamme allumée. La couronne de flamme n'est pas de niveau. Les orifices du répartiteur de Assurez-vous que le répartiflamme sont bouchés par teur de flamme est propre. des résidus alimentaires. 7.2 Si vous ne trouvez pas de solution...
www.aeg.com 8. INSTALLATION AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 8.1 Avant l'installation Avant d'installer la table de cuisson, notez les informations de la plaque signalétique ci-dessous. La plaque signalétique se trouve au bas de la table de cuisson. Modèle ........................... PNC ............................. Numéro de série .................... 8.
FRANÇAIS dans le chapitre « Caractéristiques techniques »). 4. Assemblez les pièces et suivez la même procédure dans l'ordre inverse. 5. Remplacez la plaque signalétique (qui se trouve près du tuyau d'arrivée de gaz) par celle correspondant au nouveau type d'alimentation en gaz. Vous trouverez cette plaque dans le sachet fourni avec l'appareil.
www.aeg.com 8.6 Câble d'alimentation 8.8 Possibilités d'insertion Pour remplacer le câble d'alimentation, utilisez uniquement le câble spécial ou son équivalent. Le type de câble est : H05SS-F T180. Le panneau installé sous la table de cuisson doit être facile à retirer et facilement accessible au cas où une intervention technique serait nécessaire. Assurez-vous que la section du câble convient à la tension et à la température de fonctionnement.
FRANÇAIS sécurité et pour permettre un retrait facile du four de l'ensemble. 9. CARACTÉRISTIQUES TECHNIQUES 9.1 Dimensions de la table de cuisson Largeur 595 mm Profondeur 520 mm 9.2 Diamètres des vis de réglage BRÛLEUR Ø VIS DE RÉGLAGE 1/100 mm Rapide 56 Semi-rapide 42 Auxiliaire 34 9.
www.aeg.com BRÛLEUR PUISSANCE NORMALE kW PUISSANCE MINIMALE kW MODÈLE D'INJECTEUR 1/100 mm Auxiliaire 1,0 0,33 71 10. EN MATIÈRE DE PROTECTION DE L'ENVIRONNEMENT Recyclez les matériaux portant le électroniques. Ne jetez pas les appareils symbole . Déposez les emballages dans les conteneurs prévus à cet effet. Contribuez à la protection de l'environnement et à votre sécurité, recyclez vos produits électriques et portant le symbole avec les ordures ménagères.
FRANÇAIS 19
867305255-A-392014 www.aeg.