HG694340XB EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. • Do not store items on the cooking surfaces. • Do not use a steam cleaner to clean the appliance. • Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. • If the glass ceramic surface is cracked, switch off the appliance to avoid the possibility of electric shock. 2.
ENGLISH • Make sure not to cause damage to the mains plug (if applicable) or to the mains cable. Contact the Service or an electrician to change a damaged mains cable. • The electrical installation must have an isolation device which lets you disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm.
www.aeg.com • Make sure pots are centrally positioned on the rings and do not stick out over edges of the cooking surface. • Use only the accessories supplied with the appliance. • Do not install a flame diffuser on the burner. • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. 2.4 Disposal WARNING! Risk of injury or suffocation. 2.3 Care and Cleaning WARNING! Risk of damage to the appliance.
ENGLISH 7 4. DAILY USE WARNING! Refer to the Safety chapters. 4.1 Ignition of the burner WARNING! Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame Always light the burner before you put cookware. To light the burner: Turn the control knob counterclockwise to the maximum position ( ) and push it down. 2. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up.
www.aeg.com 5. HELPFUL HINTS AND TIPS WARNING! Refer to the Safety chapters. 5.1 Energy savings • If possible, always put the lids on the pans. • When the liquid starts to boil, turn down the flame to barely simmer the liquid. Use cookware with diameters applicable to the size of burners. WARNING! Make sure that pot handles is not above the front edge of the cooktop. Make sure that pots are centrally put on the rings in order to get maximum stability and to get lower gas consumption.
ENGLISH • The pan supports are not dishwasher proof. They must be washed by hand. • When you wash the pan supports by hand, take care when you dry them as the enamelling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner. • Make sure you position the pan supports correctly after cleaning. • To make the burners work correctly, make sure that the arms of the pan supports are in the centre of the burner.
www.aeg.com Problem Possible cause Remedy The flame is blow out im- • Thermocouple is not mediately after ignition heated sufficient The gas ring burns unevenly • After lightning the flame, keep the knob pushed for approximately 5 seconds. • Burner crown is • Make sure that the inblocked with food resijector is not blocked dues and the burner crown is clear of food particles. If there is a fault, first try to find a solution to the problem yourself.
ENGLISH 11 8. INSTALLATION WARNING! Refer to the Safety chapters. WARNING! The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. 8.1 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition).
www.aeg.com The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. Make sure that the main connection pipe does not exert any strain on the hob. If you use flexible metal pipes make sure that they agree to ISO 10380 and ISO 10807 standards. Be careful they do not come in touch with mobile parts or they are not squeezed.
ENGLISH Electrical Requirements A B Permanent electrical installation must agree with the latest I.E.E. Regulations and local Electricity Board regulations. For your own safety the installation must be done by a qualified electrician (e.g. your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting [NICEIC]). C D The manufacturer refuses to be held responsible, if these safety measures are not abided by.
www.aeg.com To replace the connection cable use only H05V2V2-F T90 or equivalent type. Make sure that the cable section is applicable to the voltage load and the working temperature. The yellow/green earth wire (B) must be approximately 2 cm longer than the live and neutral wire (A). A B A A) supplied brackets CAUTION! Install the appliance only on a worktop with flat surface. 8.
ENGLISH 15 9. TECHNICAL INFORMATION Electric supply: Hob dimensions Width: 576 mm Length: 516 mm Hob recess dimensions 230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Width: 560 (0 / +2) mm Category: II2H3+ Length: 490 (0 / +2) mm Gas connection: G 1/2" Heat input Gas supply: Rapid burner: 2.9 kW Appliance class: G20 (2H) 20 mbar Semi-rapid burner: 1.9 kW By-pass diameters Auxiliary burner: 1.0 kW TOTAL POWER: G20 (2H) 20 mbar = 7.
www.aeg.com 10. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
ENGLISH 17
www.aeg.
ENGLISH 19
397248703-A-492012 www.aeg.