EN User Manual Hob HG795540XB
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 7 4. DAILY USE...................................................................................................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.aeg.com • • • • • • • • Do not store items on the cooking surfaces. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Do not use a steam cleaner to clean the appliance. If the glass ceramic surface / glass surface is cracked, switch off the appliance to avoid the possibility of electric shock.
ENGLISH • Protect the bottom of the appliance from steam and moisture. • Do not install the appliance adjacent to a door or under a window. This prevents hot cookware to fall from the appliance when the door or the window is opened. • If the appliance is installed above drawers make sure that the space, between the bottom of the appliance and the upper drawer, is sufficient for air circulation. • The bottom of the appliance can get hot.
www.aeg.com • Remove all the packaging, labelling and protective film (if applicable) before first use. • Use this appliance in a household environment. • Do not change the specification of this appliance. • Make sure that the ventilation openings are not blocked. • Do not let the appliance stay unattended during operation. • Set the cooking zone to “off” after each use. • Do not put cutlery or saucepan lids on the cooking zones. They can become hot.
ENGLISH • Do not clean the burners in the dishwasher. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Flat the external gas pipes. 2.6 Disposal WARNING! Risk of injury or suffocation. • Contact your municipal authority for information on how to discard the appliance correctly. 2.7 Service • To repair the appliance contact an Authorised Service Centre. • Use original spare parts only. 3. PRODUCT DESCRIPTION 3.
www.aeg.com 4.1 Burner overview A WARNING! Be very careful when you use open fire in the kitchen environment. The manufacturer declines any responsibility in case of the flame misuse. 1. Push the control knob down and turn it counterclockwise to the maximum B C If after some tries the burner does not light, check if the crown and its cap are in correct positions.
ENGLISH The spark generator can start automatically when you switch on the mains, after installation or a power cut. It is normal. 9 4.3 Turning the burner off To put the flame out, turn the knob to the off position . WARNING! Always turn the flame down or switch it off before you remove the pans from the burner. Each control knob has a pilot light. It lights up when you turn the control knob. 5. HINTS AND TIPS WARNING! Refer to Safety chapters.
www.aeg.com WARNING! Do not use knives, scrapers or similar instruments to clean the surface of the glass or between the rims of the burners and the frame (if applicable). • Wash stainless steel parts with water, and then dry them with a soft cloth. 6.2 Pan supports The pan supports are not resistant to washing in a dishwasher. They must be washed by hand. 1. Remove the pan supports to easily clean the hob. Be very careful when you replace the pan supports to prevent the hob top from damage. 2.
ENGLISH Problem 11 Possible cause Remedy The fuse is released. Make sure that the fuse is the cause of the malfunction. If the fuse releases again and again, contact a qualified electrician. Burner cap and crown are placed incorrectly. Place the burner cap and crown correctly. The flame extinguishes immediately after ignition. Thermocouple is not heated up sufficiently. After lightning the flame, keep the knob pushed for equal or less than 10 seconds. The flame ring is uneven.
www.aeg.com 7.3 Labels supplied with the accessories bag Stick the adhesive labels as indicated below: A B MOD. MOD. PROD.NO. PROD.NO. SER.NO SER.NO DATA DATA C MOD. PROD.NO. SER.NO. 0049 TYPE IP20 03 IT MADE IN ITALY A) Stick it on Guarantee Card and send this part (if applicable). B) Stick it on Guarantee Card and keep this part (if applicable). C) Stick it on instruction booklet. 8. INSTALLATION WARNING! Refer to Safety chapters. 8.
ENGLISH 13 However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m³ and 11 m³. If there are other fuel burning appliances in the same room, B.S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements. For appliances installed in the Republic of Ireland please refer to the NSAIDomestic Gas Installation I.S. 813 Current Editions Table Four.
www.aeg.com 8.4 Injectors replacement 1. Remove the pan supports. 2. Remove the caps and crowns of the burner. 3. With a socket spanner 7 remove the injectors and replace them with the ones which are necessary for the type of gas you use (see table in "Technical Information" chapter). 4. Assemble the parts, follow the same procedure backwards. 5. Replace the rating plate (it is near the gas supply pipe) with the one for the new type of gas supply.
ENGLISH Before carrying out the connection, make sure: 1. The limiter valve and the electrical system can take the appliance load (see the rating plate) 2. The supply system is equipped with an efficient earth connection in compliance with the current standards and regulations 3. The outlet or omnipolar switch used for connection is easily accessible with the appliance installed. The appliance is supplied with a 3 core flexible power cable with a 3 amp plug.
www.aeg.com 8.8 Building In A) supplied seal B) supplied brackets CAUTION! Install the appliance only on a worktop with flat surface. min. 600 mm min. 650 mm min. 450 mm 8.9 Possibilities for insertion min. 55 mm 40 mm +2 490 0 mm The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary.
ENGLISH 17 9.3 Other technical data Gas original: G20 (2H) 20 mbar = 10,5 kW TOTAL POWER: Gas replacement: G30 (3+) 28-30 mbar = 763 g/h G31 (3+) 37 mbar = 750 g/h Electric supply: 230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse Appliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 9.
www.aeg.com Energy efficiency per gas burner (EE gas burner) Left middle - Triple Crown 54.4% Centre rear - Semi-rapid 62.3% Right rear - Semi-rapid 62.3% Right front - Semi-rapid 62.3 Energy efficiency for the gas hob (EE gas hob) 60.3% EN 30-2-1: Domestic cooking appliances burning gas - Part 2-1 : Rational use of energy - General 10.2 Energy saving • • • • • • • Before use, make sure that the burners and pan supports are assembled correctly.
ENGLISH 19
867305402-C-072015 www.aeg.
