FR Notice d'utilisation Table de cuisson HK653222SB
www.aeg.com TABLE DES MATIÈRES 1. CONSIGNES DE SÉCURITÉ........................................................................................... 3 2. INSTRUCTIONS DE SÉCURITÉ...................................................................................... 4 3. DESCRIPTION DE L'APPAREIL...................................................................................... 7 4. UTILISATION QUOTIDIENNE........................................................................................9 5.
FRANÇAIS 1. 3 CONSIGNES DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne peut être tenu pour responsable des dommages et blessures liés à une mauvaise installation ou utilisation. Conservez toujours cette notice avec votre appareil pour vous y référer ultérieurement. 1.
www.aeg.com • • • • • • • • Il peut être dangereux de laisser chauffer de la graisse ou de l'huile sans surveillance sur une table de cuisson car cela pourrait provoquer un incendie. N'essayez jamais d'éteindre un feu avec de l'eau. Éteignez l'appareil puis couvrez les flammes, par exemple avec un couvercle ou une couverture ignifuge. N'entreposez rien sur les surfaces de cuisson.
FRANÇAIS panneau de séparation ignifuge sous l'appareil pour en bloquer l'accès. • Assurez-vous de laisser un espace de ventilation de 2 mm entre le plan de travail et l'avant de l'unité qui se trouve dessous. La garantie ne couvre pas les dommages causés par l'absence d'un espace de ventilation adéquat. 2.2 Branchement électrique AVERTISSEMENT! Risque d'incendie ou d'électrocution. • L'ensemble des branchements électriques doit être effectué par un technicien qualifié.
www.aeg.com • N'utilisez jamais cet appareil avec les mains mouillées ou lorsqu'il est en contact avec de l'eau. • N'utilisez jamais l'appareil comme plan de travail ou comme plan de stockage. • Si la surface de l'appareil présente des fêlures, débranchez immédiatement l'appareil pour éviter tout risque d'électrocution. • Les porteurs de pacemakers doivent rester à une distance minimale de 30 cm des zones de cuisson à induction lorsque l'appareil est en cours de fonctionnement.
FRANÇAIS 7 3. DESCRIPTION DE L'APPAREIL 3.1 Description de la table de cuisson 1 1 1 Zone de cuisson à induction 2 Panneau de commande 145 mm 180/280 mm 210 mm 1 2 3.2 Description du bandeau de commande 1 2 3 4 5 10 9 6 8 7 Les touches sensitives permettent de faire fonctionner l'appareil. Les affichages, les voyants et les signaux sonores indiquent les fonctions activées. Touche sensitive Fonction Description 1 MARCHE/ARRÊT Pour allumer et éteindre la table de cuisson.
www.aeg.com Touche sensitive 7 / 8 9 10 - Fonction Description - Pour choisir la zone de cuisson. - Pour augmenter ou diminuer la durée. Fonction Booster Pour activer et désactiver la fonction. Bandeau de sélection Pour sélectionner un niveau de cuisson. 3.3 Indicateurs de niveau de cuisson Affichage Description La zone de cuisson est désactivée. La zone de cuisson est activée. - La fonction STOP+GO est activée. La fonction Démarrage automatique de la cuisson est activée.
FRANÇAIS 9 4. UTILISATION QUOTIDIENNE AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 4.1 Activation et désactivation Appuyez sur pendant 1 seconde pour activer ou désactiver la table de cuisson. 4.
www.aeg.com induction. La fonction peut être activée pour la zone de cuisson à induction uniquement pour une durée limitée. Lorsque cette durée est écoulée, la zone de cuisson à induction revient automatiquement au niveau de cuisson le plus élevé. Reportez-vous au chapitre « Caractéristiques techniques ». Pour voir le temps restant : sélectionnez la zone de cuisson à l'aide de . Le voyant de la zone de cuisson clignote rapidement. L'affichage indique la durée restante.
FRANÇAIS Minuterie Vous pouvez utiliser cette fonction comme Minuterie lorsque la table de cuisson est allumée mais que vous n'utilisez pas les zones de cuisson (le niveau de cuisson indiqué est ). Pour activer la fonction : appuyez sur . Appuyez sur la touche ou du minuteur pour régler la durée. Lorsque la durée s'est écoulée, un signal sonore retentit et 00 clignote. Pour arrêter le signal sonore : appuyez sur . Cette fonction est sans effet sur le fonctionnement des zones de cuisson.
www.aeg.com Pour confirmer le réglage, attendez que la table de cuisson s'éteigne automatiquement. Lorsque cette fonction est réglée sur l'appareil émet des signaux sonores uniquement lorsque : • • • • , vous appuyez sur Minuterie se termine Minuteur dégressif se termine vous posez un objet sur le bandeau de commande. • La fonction s'active lorsque la charge électrique totale des zones de cuisson dépasse 7400 W. • La fonction diminue la puissance des autres zones de cuisson.
FRANÇAIS • un craquement : le récipient est composé de différents matériaux (conception « sandwich »). • un sifflement : vous utilisez la zone de cuisson avec un niveau de puissance élevé et le récipient est composé de différents matériaux (conception « sandwich »). • un bourdonnement : vous utilisez un niveau de puissance élevé. • un cliquetis : des commutations électriques se produisent. • un sifflement, un bourdonnement : le ventilateur fonctionne.
www.aeg.com Niveau de cuisson Utilisation : Durée (min) Conseils 9 - 12 Poêler à feu doux : escalopes, cordons-bleus de veau, côtelettes, rissolettes, saucisses, foie, roux, œufs, crêpes, beignets. au besoin Retournez à la moitié du temps de décongélation. 12 - 13 Cuisson à température élevée 5 - 15 des pommes de terre rissolées, filets, steaks. 14 Faire bouillir de l'eau, cuire des pâtes, cuire de la viande (goulasch, bœuf braisé), cuire des frites.
FRANÇAIS 15 7.1 En cas d'anomalie de fonctionnement... Problème Cause probable Solution Vous ne pouvez pas mettre en fonctionnement la table de cuisson. La table de cuisson n'est pas connectée à une source d'alimentation électrique ou le branchement est incorrect. Vérifiez que la table de cuisson est correctement branchée à une source d'alimentation électrique. Reportezvous au schéma de branchement. Le fusible a disjoncté. Vérifiez que le fusible est bien la cause de l'anomalie.
www.aeg.com Problème Cause probable Solution Le niveau de cuisson change. La fonction Gestionnaire de puissance est activée. Reportez-vous au chapitre « Utilisation quotidienne ». Les touches sensitives sont chaudes. Le récipient est trop grand ou vous l'avez placé trop près des commandes. Placez les récipients de grande taille sur les zones arrière, si possible. Aucun signal sonore ne se Les signaux sont désactivés. fait entendre lorsque vous appuyez sur les touches sensitives du bandeau.
FRANÇAIS Problème s'allume. 17 Cause probable Solution Une erreur s'est produite sur la table de cuisson parce que le récipient chauffe à vide. Arrêt automatique et la protection contre la surchauffe des zones s'activent. Éteignez la table de cuisson. Enlevez le récipient chaud. Au bout d'environ 30 secondes, remettez la zone en fonctionnement. Si le problème était causé par le récipient, le message d'erreur disparaît. Voyant de chaleur résiduelle peut rester affiché.
www.aeg.com 8.4 Montage min. 500mm min. 50mm min. 2mm min. 2 mm A min. 2 mm A B < 20 mm > 20 mm min. 500 mm B 57 mm 41 mm 31 mm A 12 mm 28 mm 38 mm B min 30 mm min. 500 mm A 12 mm 28 mm 38 mm B 57 mm 41 mm 31 mm min. 38 mm min. 2 mm R 5mm min.
FRANÇAIS 19 min. 12 mm min. 2 mm 8.5 Enceinte de protection Si vous utilisez une enceinte de protection (accessoire supplémentaire), l'espace de circulation d'air de 2 mm et le fond de protection installé directement sous la table de cuisson ne sont plus nécessaires. L'enceinte de protection n'est pas disponible dans tous les pays. Veuillez contacter votre revendeur local. Vous ne pouvez pas utiliser l'enceinte de protection si vous installez la table de cuisson au-dessus d'un four. 9.
www.aeg.com 9.2 Caractéristiques des zones de cuisson Zone de cuisson Puissance nom- Fonction Boosinale (niveau ter [W] de cuisson max.) [W] Fonction Boos- Diamètre du réter durée maxi- cipient [mm] male [min] Avant gauche 2300 3700 10 180 - 210 Arrière gauche 1400 2500 4 125 - 145 Arrière droite 1800 / 3500 2800 / 5200 5 145 - 180 / 245 280 La puissance des zones de cuisson peut légèrement différer des données du tableau. Elle dépend de la matière et des dimensions du récipient.
FRANÇAIS 21 11. EN MATIÈRE DE PROTECTION DE L'ENVIRONNEMENT Recyclez les matériaux portant le électroniques. Ne jetez pas les appareils symbole . Déposez les emballages dans les conteneurs prévus à cet effet. Contribuez à la protection de l'environnement et à votre sécurité, recyclez vos produits électriques et portant le symbole avec les ordures ménagères. Emmenez un tel produit dans votre centre local de recyclage ou contactez vos services municipaux.
www.aeg.
FRANÇAIS 23
867311720-A-492014 www.aeg.