User manual

Problem Possible cause Remedy
There is no signal when you
touch the panel sensor
fields.
The signals are deactivated. Activate the signals.
Refer to "Daily use" chapter.
The flexible induction cook-
ing area does not heat up
the cookware.
The cookware is in the
wrong position on the flexi-
ble induction cooking area.
Place the cookware in the
correct position on the flexi-
ble induction cooking area.
The position of the cook-
ware depends on the activa-
ted function or function
mode.
Refer to "Flexible induction
cooking area" chapter.
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Use cookware with diameter
applicable to the activated
function or function mode.
Use cookware with diameter
smaller than 160 mm on a
single section of the flexible
induction cooking area.
Refer to "Flexible induction
cooking area" chapter.
comes on.
Automatic Switch Off oper-
ates.
Deactivate the hob and acti-
vate it again.
comes on.
The Child Safety Device or
the Lock function operates.
Refer to "Daily use" chapter.
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to “Hints and tips”
chapter.
The diameter of the bottom
of the cookware is too small
for the zone.
Use cookware with correct
dimensions.
Refer to “Technical informa-
tion” chapter.
FlexiBridge function oper-
ates. One or more sections
of the function mode which
operates are not covered by
the cookware.
Place the cookware on the
correct number of sections
of the function mode which
operates or change the func-
tion mode.
Refer to "Flexible induction
cooking area" chapter.
www.aeg.com20