User manual

Incorrect cookware position:
6.5 PowerSlide function
This function allows you to adjust the
temperature by moving the cookware to
a different position on the induction
cooking area.
The function divides the induction
cooking area into three areas with
different heat settings. The hob detects
the position of the cookware and adjust
the heat setting corresponding with the
position. You can place the cookware in
the front, middle or rear position. If you
place the cookware in the front you get
the highest heat setting. To decrease it,
move the cookware to middle or rear
position.
Use only one pot when you
operate the function.
General information:
160 mm is the minimum bottom
diameter of the cookware for this
function.
Heat setting display for the left rear
control bar shows the position of the
cookware on the induction cooking
area. Front , middle , rear
.
Heat setting display for the left front
control bar shows the heat setting. To
change the heat setting use left
front control bar.
When you activate the function for the
first time you will get heat setting
for the front position, for the
middle position and for the rear
position.
You can change the heat settings for
each position separately. The hob will
remember your heat settings next
time you activate the function.
www.aeg.com
18