Convection Oven User Manual

Installing the oven door

1. Hold the door with one hand on each

side at an angle of approximately 60°

(from the side of the door with the han-

dle turn to you).

2. Push door hinges at the same time into

the two recesses at the bottom of the

oven on the left and the right, as far as

they will go.

3. Lift the door up until you meet the point of resistance and then open it as far as possible.

4. Fully lock the clamping levels on the hinges.

5. Close the oven door.

WHAT TO DO IF…

WARNING!

Refer to "Safety information" chapter.

Problem Possible cause Solution

The appliance does not heat up The appliance is deactivated Activate the appliance

The appliance does not heat up The time of day is not set Set the time of day. Refer to

"Setting the time of day"

The appliance does not heat up The necessary settings are not

set

Make sure, the settings are cor-

rect

The appliance does not heat up The automatic switch-off is ac-

tivated

Refer to „Automatic switch-

off“

The appliance does not heat up The child safety is activated Deactivate the child safety

The appliance does not heat up The fuse is released Make sure, if the fuse is the

cause for the malfunction. If

the fuse releases again and

again, refer to an authorized

electrician

The oven lamp does not operate The oven lamp is defective Replace the oven lamp.

"d" is lit in the display and the

oven does not heat up

Fan does not operate

Test mode is switched on Switch off the appliance.

Touch and hold and at

the same time, until signal

sounds and "d" display goes out

If you cannot find a solution to the problem yourself, contact your dealer or the service

centre.

The necessary data for the service centre is on the rating plate. The rating plate is on the

front frame of the oven cavity.

We recommend that you write the data here:

What to do if…