FR Notice d'utilisation Table de cuisson KFA58SIO
www.aeg.com 2 TABLE DES MATIÈRES 1. INFORMATIONS DE SÉCURITÉ.............................................................................. 2 2. CONSIGNES DE SÉCURITÉ..................................................................................... 5 3. DESCRIPTION DE L'APPAREIL................................................................................ 7 4. UTILISATION QUOTIDIENNE..................................................................................9 5. CONSEILS.........................
FRANÇAIS 3 dégâts résultant d'une mauvaise installation ou utilisation. Conservez toujours les instructions dans un lieu sûr et accessible pour vous y référer ultérieurement. 1.
www.aeg.com • • • • • • • • • • AVERTISSEMENT : Il peut être dangereux de laisser chauffer de la graisse ou de l'huile sans surveillance sur une table de cuisson car cela pourrait provoquer un incendie. N'essayez JAMAIS d'éteindre un feu avec de l'eau. Éteignez l'appareil puis couvrez les flammes, par exemple avec un couvercle ou une couverture ignifuge. ATTENTION : Toute cuisson doit être surveillée. Une cuisson courte doit être surveillée en permanence.
FRANÇAIS 5 2. CONSIGNES DE SÉCURITÉ 2.1 Installation AVERTISSEMENT! L'appareil doit être installé uniquement par un professionnel qualifié. • Retirez l'intégralité de l'emballage. • N'installez pas et ne branchez pas un appareil endommagé. • Suivez scrupuleusement les instructions d'installation fournies avec l'appareil. • Respectez l'espacement minimal requis par rapport aux autres appareils et éléments. • Soyez toujours vigilants lorsque vous déplacez l'appareil car il est lourd.
www.aeg.com • Si la prise de courant est lâche, ne branchez pas la fiche d'alimentation secteur. • Ne tirez jamais sur le câble d'alimentation pour débrancher l'appareil. Tirez toujours sur la fiche. • N'utilisez que des systèmes d'isolation appropriés : des coupecircuits, des fusibles (les fusibles à visser doivent être retirés du support), un disjoncteur différentiel et des contacteurs. • L'installation électrique doit être équipée d'un dispositif d'isolement à coupure omnipolaire.
FRANÇAIS Soulevez toujours ces objets lorsque vous devez les déplacer sur la surface de cuisson. • Cet appareil est exclusivement destiné à un usage culinaire. Ne l'utilisez pas pour des usages autres que celui pour lequel il a été conçu, à des fins de chauffage par exemple. 2.4 Entretien et nettoyage • Nettoyez régulièrement l'appareil afin de maintenir le revêtement en bon état. • Éteignez l'appareil et laissez-le refroidir avant de le nettoyer.
www.aeg.com 3.2 Description du bandeau de commande 1 2 3 4 10 5 9 6 8 7 Les touches sensitives permettent de faire fonctionner l'appareil. Les affichages, les voyants et les signaux sonores indiquent les fonctions activées. TouFonction che sensitive Commentaire 1 MARCHE/ARRÊT 2 Verrouillage / Dispositif de Pour verrouiller ou déverrouiller le bandeau sécurité enfants de commande. 3 STOP+GO Pour activer et désactiver la fonction.
FRANÇAIS Affichage - / 9 Description - La zone de cuisson est activée. Le point indique que le niveau de cuisson a changé de moitié. La fonction STOP+GO est activée. La fonction Démarrage automatique de la cuisson est activée. Fonction Booster est activée. + chiffre Une anomalie de fonctionnement s'est produite. Une zone de cuisson est encore chaude (chaleur résiduelle). La fonction Verrouillage /Dispositif de sécurité enfants est activée.
www.aeg.com La relation entre le niveau de cuisson et la durée après laquelle la table de cuisson s'éteint : Niveau de cuisson La table de cuisson s'éteint au bout de uniquement pour une durée limitée. Lorsque cette durée est écoulée, la zone de cuisson à induction revient automatiquement au niveau de cuisson le plus élevé. Reportez-vous au chapitre « Caractéristiques techniques ».
FRANÇAIS Lorsque la durée est écoulée, un signal sonore retentit et 00 clignote. La zone de cuisson se désactive. Pour arrêter le signal sonore : appuyez sur . Minuterie Vous pouvez utiliser cette fonction comme Minuterie lorsque la table de cuisson est allumée mais que les zones de cuisson ne sont pas activées. L'affichage du niveau de cuisson indique . Pour activer la fonction : appuyez sur . Appuyez sur la touche ou du minuteur pour régler la durée.
www.aeg.com • Chaque phase dispose d'une charge électrique maximale de 3 700 W. • La fonction répartit la puissance entre les zones de cuisson raccordées à la même phase. • La fonction s'active lorsque la charge électrique totale des zones de cuisson raccordées à une phase simple dépasse 3 700 W. • La fonction diminue la puissance des autres zones de cuisson raccordées à la même phase. • L'affichage du niveau de cuisson des zones à puissance réduite oscille entre deux niveaux. 5.
FRANÇAIS 5.3 Exemples de cuisson Le rapport entre le niveau de cuisson et la consommation énergétique de la zone de cuisson n'est pas linéaire. Lorsque vous augmentez le niveau de cuisson, l'augmentation énergétique de la zone de cuisson n'est pas proportionnelle. Cela signifie que la zone de cuisson Niveau de cuisson Utilisation : 13 utilisée à un niveau de cuisson moyen utilise moins de la moitié de sa puissance. Les valeurs figurant dans le tableau suivant sont fournies à titre indicatif.
www.aeg.com 6. ENTRETIEN ET NETTOYAGE AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 6.1 Informations générales • Nettoyez la table de cuisson après chaque utilisation. • Utilisez toujours un plat de cuisson dont le fond est propre. • Les rayures ou les taches sombres sur la surface n'ont aucune incidence sur le fonctionnement de la table de cuisson. • Utilisez un nettoyant spécialement adapté à la surface de la table de cuisson. • Utilisez un racloir spécial pour la vitre. 6.
FRANÇAIS Problème Cause probable 15 Solution Allumez de nouveau la table de cuisson et réglez le niveau de cuisson en moins de 10 secondes. Vous avez appuyé sur plusieurs touches sensitives en même temps. N'appuyez que sur une seule touche sensitive à la fois. La fonction STOP+GO est activée. Reportez-vous au chapitre « Utilisation quotidienne ». Il y a de l'eau ou des taches Nettoyez le bandeau de de graisse sur le bandeau de commande. commande.
www.aeg.com Problème s'allume. Cause probable Solution Il n'y a pas de récipient sur la Placez un récipient sur la zozone de cuisson. ne de cuisson. Le récipient n'est pas adapté. Utilisez un récipient adapté. Reportez-vous au chapitre « Conseils ». Le diamètre du fond du réci- Utilisez un récipient de dipient de cuisson est trop pe- mensions appropriées. tit pour la zone de cuisson. Reportez-vous au chapitre « Caractéristiques techniques ». et un chiffre s'affichent.
FRANÇAIS 17 8. INSTALLATION AVERTISSEMENT! Reportez-vous aux chapitres concernant la sécurité. 8.1 Avant l'installation Avant d'installer la table de cuisson, notez les informations de la plaque signalétique ci-dessous. La plaque signalétique se trouve au bas de la table de cuisson. Numéro de série .................... 8.
www.aeg.com 8.6 Montage min. 500mm min. 50mm min. 2mm min. 2 mm min. 2 mm A B < 20 mm B > 20 mm min 30 mm min. 500 mm A 12 mm 28 mm 38 mm A B 57 mm 41 mm 31 mm min. 500 mm A 12 mm 28 mm 38 mm B 57 mm 41 mm 31 mm R10mm R5mm 7mm 12mm min. 55mm 490+1mm 560+1mm 514+1mm 584+1mm min. 38 mm min.
FRANÇAIS 19 min. 12 mm min. 2 mm 8.7 Enceinte de protection Si vous utilisez une enceinte de protection (accessoire supplémentaire), l'espace de circulation d'air de 2 mm et le fond de protection installé directement sous la table de cuisson ne sont plus nécessaires. L'enceinte de protection n'est pas disponible dans tous les pays. Veuillez contacter votre revendeur local. Vous ne pouvez pas utiliser l'enceinte de protection si vous installez la table de cuisson au-dessus d'un four. 9.
www.aeg.com 9.2 Caractéristiques des zones de cuisson Zone de cuisson Puissance noFonction Boosminale (réglage ter [W] de chaleur maximum) [W] Fonction Boos- Diamètre de ter durée maxi- l'ustensile de male [min] cuisson [mm] Avant gauche 2300 3700 10 180 - 210 Arrière gauche 1800 2800 10 145 - 180 Avant droite 1400 2500 4 125 - 145 Arrière droite 1800 2800 10 145 - 180 La puissance des zones de cuisson peut être légèrement différente des données indiquées par la table.
FRANÇAIS • Si possible, couvrez toujours les récipients de cuisson avec un couvercle pendant la cuisson. • Activez toujours la zone de cuisson après avoir posé le récipient dessus. • Placez les plus petits récipients sur les plus petites zones de cuisson. 11. CH 21 • Posez directement le récipient au centre de la zone de cuisson. • Vous pouvez utiliser la chaleur résiduelle pour conserver les aliments au chaud ou pour faire fondre.
www.aeg.com Pour la Suisse: Où aller avec les appareils usagés ? Partout où des appareils neufs sont vendus, mais aussi dans un centre de collecte ou une entreprise de récupération officiels SENS. La liste des centres de collecte officiels SENS est disponible sous www.erecycling.
FRANÇAIS 23
867331678-A-312016 www.aeg.