User manual

Installing the shelf support
To install the shelf support follow the
procedure in the opposite order.
11.2 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass
cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity
ceiling:
1.
Turn the lamp glass cover counter-
clockwise to remove it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
12. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Remedy
The appliance does not
heat up.
The appliance is deacti-
vated.
Activate the appliance.
The appliance does not
heat up.
The clock is not set. Set the clock. Refer to
"Setting the clock".
The appliance does not
heat up.
The necessary settings
are not set.
Make sure that the set-
tings are correct.
The appliance does not
heat up.
The automatic cut-out is
activated.
Refer to “Automatic
switch-off”.
The appliance does not
heat up.
The fuse is released. Make sure that the fuse
is the cause of the mal-
function. If the fuse re-
leases again and again,
contact a qualified elec-
trician.
The lamp does not oper-
ate.
The lamp is defective. Replace the lamp.
The display shows an er-
ror code that is not on
this list.
There is an electrical
fault.
• Deactivate the appli-
ance with the house
fuse or the safety
switch in the fuse box
and activate it again.
• If the display shows
the error code again,
contact the Customer
Care Department.
ENGLISH 33