User manual

8
www.aeg.com
• If the appliance or the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualied person, in order to
avoid hazard.
• Always place the appliance on a at, level surface.
• Always disconnect the appliance from the supply if it is left unattended and
before assembling, disassembling or cleaning.
• Appliance is for indoor use only.
• Do not immerse the appliance, cord or plug in water or any other liquid.
• Do not let cord hang over edge of table or counter, do not let cord contact
hot surface, including the stove.
• Never use accessories or parts made by other manufactures not
recommended or sold; may cause a risk of injury to persons.
• Make sure the motor has completely stopped before disassembling and
cleaning.
• Avoid contact with moving parts. Contact could result in injury! Do not use
other tools or utensils during the appliance usage.
• Do not leave this product out of your sight when it is running.
• Ensure all loose matters and your clothes/accessories are kept away while
using this product.
• Never process boiling liquids (max 90°C).
• Do not use this appliance to stir paint. Danger, could result in an explosion!
• Never operate appliance with the attachments wire whip, at beater or
dough hook unless the bowl is in place.
• This appliance is intended for domestic use only. The manufacturer cannot
accept any liability for possible damage caused by improper or incorrect
use.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The motor slows down
during operation.
Amount of dough may exceed maximum
capacity.
Remove half and process in two batches.
Dough may be too wet, it sticks onto the side
of the bowl..
Add more our, 1 tablespoon at a time
until the motor speeds up. Process until
dough cleans the side of the bowl.
The motor does not work. The appliance is not connected to the mains. Make sure to plug in the appliance
before operation.
The appliance vibrates/
moves during operation.
The rubber feet are wet. Make sure the rubber feet at the bottom
of the unit are clean and dry.
It is normal for heavy loads (e.g heavy dough,
cheese).
Remove half and process in two batches.
The attachment scrapes
the Stainless steel bowl
during operation.
The height of the attachment shaft is incorrect. Adjust the height of the attachment
shaft.
KM4xxx_StandMixer_AEG NO-FARSI.indd 8 2017-07-06 13:02:06