COOKER HOBS Gas KG 740 Mixed KM 731 T Electric K740 T AEG (UK) LTD-, Bath Road, Slough, Berkshire SLY AW Tel : Slough 872101 52238
Index INSTRUCTIONS FOR USE Description .. ~ Gas burners .. Automatic plates SUITABLE PANS L. . mitt i sett i awakens MAINTENANCE . ..ttt i cast oot iy e v iaainnnenaronnons INSTALLATION INSTRUCTIONS ens Casing .. Fitting air-tight seal Fitting the hob Gas connection and settings Electrical connection Guarantee AGE-Telef 1 (UK} Ltd guarantees to replace free of charge fc 1@ year, to the first retail purchaser, any parts or components which fail due to workmanship or materials.
‘Description Gas hob High Speed 2,79 kW Ultra fast 3,25 kW Mixed Hobs Automatic plate with simmer control sensor G180 2000 Ultra Fast 3,25 kW Electric hob Automatic plate with simmer control sensor @ 180 2000 W High Speed 2,79 kW Fast 1,62 kW High Speed Switch of timer, for use with automatic plate back left Indicator lights Fast 1,62 kW Normal piste 7 positions & 145 1000 W Switch off timer, for use with automatic plate back left indicator lights Automatic plate with simmer control sensor.
Use of the gas burners OPERATION A guide mark above each control indicates which burner is being used. Each burner is supplied with gas by a tap which incorporates a safety catch and a slow burning position. * s HIGH FLAME LOW FLAME LIGHTING THE BURNERS : Depress and turn the control knob of the burner anti-clockwise until it is opposite the high flame mark. This produces the sparks and ignites the burner. If the burner fails to ignite after a few seconds, switch off the control knob for 2.3 mind.
Use of the hotplates HOTPLATE WITH 7 HEAT SETTINGS This plate is controlled by a knob with six settings { + OFF setting) which allows the power to be set according to the type of cooking. USE Turn the control knob either to the left or to the right to the setting selected for cooking. Canteen knob 1 kW hotplate seven-settings To succeed in cooking, it is recommended to start off at the high setting {6} and to decrease it to lower setting, taking into account the type and volume of food.
Suitable pans Before using the electric hotplates for the first time heat them up for several minutes with out a saucepan on the maximum setting to allow the protective coating to harden. To obtain compete satisfaction from your appliance, it is necessary to follow some basic rites for example, USE OF HEAVY PANS WITH LEVEL BASES (or a raised base} DISTORTED PAN BASE LEVEL PAN BASE WRONG CORRECT A pan with a perfectly flat base allows an even distribution of heat and economical use of energy.
Maintenance THE BURNER CAPS These are not fixed, so they may be simply removed and cleaned with a slightly soapy, moist sponge, o a cleaner such as « Jif ». Do not put them into cold water immediately after use, to avoid thermal shock causing a breakage of the enamel. The use of abrasive products is not advisable, these will scratch and tarnish the enamel. If the holes are clogged, brush the caps with soapy water and dry them with a clean cloth. THE ELECTRIC HOTPLATES Wipe off the silage.
Installation UNPACKING YOUR HOB Remove the cardboard box and Styrofoam padding., The bag containing the injectors and brackets is attached to the power supply cable for gas hobs. The bag containing the attachment brackets is glued to the box of the electric hob.
Connecting and adjusting the gas GAS CONNECTION Appliances incorporated into kitchen units must be connected by means of a rigid pip. The gas hobs for building-in are therefore supplied without nozzle for a flexible pipe. Gas tap joints }w ) Connect with iron or copper piping starting from ® the threaded joint fixed on the edge of the gas hob. Make provision for a connection that can be taken apart and is easily accessible. ii NOTE : If you need to redirect the threaded joint, \“ it is possible to unscrew l
-~ CHARACTERISTICS OF GAS BURNERS Butane Propane Natural 928 Heat rate M-m3 1331 101,8 39,9 Service pressure mar 28 37 18 Fast Injector number A3 A(63) 193} Thermal output kW 1,63 1,63 1,63 Q Output per hour {g/h} 118 e 15°C, 760 mm Hg {i/hi 156 High speed (2.79 kW) injector number K {84} K (84) M (128} Thermal output kW 2,80 2,80 2,80 Output per hour {g/h) 203 200 15°C, 760 mm Hg {I/h} Ultra fast {3.
Electrical connection GAS HOB The gas hob are supplied with a cable which should be connected to a standard 13 Amp plug fitted with a 3 Amp fuse. ELECTRIC HOB This electric hob is equipped with a terminal plate which facilitates connection. It is not available with a cable. The wiring must be made by the installer. Before beginning connecting it is essential to make sure that the voltage is that which is shown on the meter.