Operation Manual

40
English
40
KRC4376CD_IM 06.05.16
Overview of the Components
1 IR Infrared sensor
2 LCD display
3 CD tray
4 ALARM button (set alarm)
5 DISPLAY button (display time during operation)
6 SOURCE button (operating mode)
7 SKIP / TUNE button (scan forwards)
8 / M+ button (play / pause / memory upwards)
9 VOLUME + button (increase volume)
10 OPEN / CLOSE button (open / close CD tray)
11 LINE IN jack
12 POWER button (on / standby / alarm off)
13 VOLUME – button (decrease volume)
14 / M – button (stop / memory downwards)
15
SKIP / TUNE button (scan backwards)
16 TIMER button (short-term timer)
17 REPEAT button (repeat)
18 CLK SET / MEM / PROG button (set time / memory)
Rear side (without illustration)
DC IN
connector
Wire antenna
Bottom side (without illustration)
Battery compartment
Remote control
19 SOURCE button
20
OPEN / CLOSE button
21 / SKIP/TUNE buttons
22 DISPLAY button
23 TIMER button
24 M+ / M – buttons
25 REPEAT button
26 VOLUME + / – buttons
27 MUTE button (mute)
28 ALARM button
29 CLK SET button
30 PROG / MEM button
31 button
32 button
33 POWER button
Assembly Instructions
CAUTION:
Make sure that the plug is not inserted when assem
-
bling the device!
NOTE:
Check the radio reception before installing the device!
• Remove all objects from the cupboard and anything
which is fragile in the adjacent cupboards.
• For the installation the cupboard must fulfil the following
conditions:
Thickness of the cupboard floor between
16 mm and 20 mm.
• The wall mounting of the cupboard must be stable and
anchored firmly in the wall with at least 2 screws.
• Important! Do not install the device above a cooker!
• When installing the device it must be ensured that there is
a power socket within reach.
• The mains socket must be within easy reach, so that the
plug can be quickly removed in an emergency.
• Important! Do not connect the device to the mains
power supply until after installation!
• The device cannot be installed under cupboards under
which there is a lighting strip.
• For mounting, you may need the following supplies: A
drill with 6 mm drill bit, pilot drill or nail, screwdriver, tape
measure, adhesive tape, scissors, safety goggles.
Supplied mounting accessories
4 Screws
4 Spacers
1 Drilling template
CAUTION:
• Please adhere to the dimensions stated in the installa
-
tion instructions.
• You should use only the installation accessories
supplied.
Installation
1. Tape the template firmly down to the shelf with adhesive
tape. With the help of a gimlet or nail pierce the crosses
at the attachment points and use it to mark the holes.
2. Remove the template and drill the holes into the wall
cupboard.
3. Insert the spacer into the holes provided on the device.
CAUTION:
Sufficient ventilation is only guaranteed with a spacer.
4. Countersink the screws into the holes in the cupboard.
5. Using the 4 screws and the spacers, attach the kitchen
radio to the bottom of the cupboard.
6. Tighten the screws finger tight with a screwdriver.
CAUTION:
Use a screwdriver and not a cordless screwdriver.
Start-up of the device / Introduction
NOTE:
• You will find some buttons both on the device and
the remote control. Identical buttons have the same
function.