Equipment and description @ Figure 1 A High sped hotplate 18 cm @ with corresponding switch B High speed hotplate 14.5 cm @ with corresponding switch € High speed roaster plate 14.
Using the hotplates Hints for couching on hotplates ® Keep the hotplates clean at ail terns because dirty plates will not traduce full baling power. ® Take advantage of the after heat: Turn the hotplates off 5-10 minutes Gator end of cooking ime, Overheated tat or oll can ignite very easily. You should therefore never fave Dishes which are being cooked In tat or oif unattended {e.g. chippie. General The symbols exterior to the control knobs indicate which knobs belongs o which hotplate.
Using the hotplates High speed roaster pale Witch on the small diameter hotplate {14.5 cm @ casuals descanted under "Boiling and frying”, The roaster plate in addition is switched on by turning the contra knob (Figure 4/F) clockwise 1o the symbol "0, Now the small diameter hotplate and the roaster plate are in operation. Dual circuit high speed hotplate The small diameter hotplate switched onion the usual manner — as described under “Boiling and frying”.
installation instructions Connection Wuhan connecting the appliance a device should be provided which permits disconnecting the appliance from the power supply with a contact gap of at least 3 mm. Suitable isolating devices will take the form of fine protection circuit breakers, fuses and compactors. The appliance is designed for permanent connection 19 380 operates on 220V AG.
Installation instructions Hob fitment in adjoining furniture units Obis with & wight of 77 om which on one side extend beyond the cooker dimension of 60 cm are installed according to Figure 7. Hob installation: 1. Take the mean according lo Figure 8. 2. Almach fastening rails according to Figure 8. 3. Cut off stop edge of listening rails {Figure 10} with a knife. 4. Insert hob canted laterally downwards {Figure 7} and place it horizontally in level in the work tap. .