L 60060 TL 1 L 60260 TL 1 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 ACCESSORIES . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH ance. Contact the Service to ensure which accessories can be used. Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.
www.aeg.com 3. PRODUCT DESCRIPTION 1 7 2 8 9 3 10 11 4 5 6 12 1 Control panel 7 Rating plate 2 Lid 8 Mains cable 3 Lid handle 4 Filter access door 9 Water inlet valve 10 Water drain hose 5 Lever to move the appliance 11 Transit bolts 6 Adjustable feet 12 Feet for the appliance level 4. ACCESSORIES 1 2 3 1 Plastic cap To close the hole on the rear side of the cabinet, after the removal of the transit bolt. 2 Plastic hose guide To connect the drain hose on the edge of a sink.
ENGLISH 7 5. CONTROL PANEL 1 2 3 9 1 On/Off button 3 Display 5 6 Start/Pause button Delay start button Time saving button 7 Liquid detergent button 8 9 7 6 5 4 The AUTO Stand-by function automatically deactivates the appliance to decrease the energy consumption when: • You do not use the appliance for 5 minutes before you press button 4 . – All settings are cancelled. – Press button 1 to activate the appliance again. – Set again the washing programme and all possible options.
www.aeg.com The display shows: A • The programme time When the programme starts, the time decreases with steps of 1 minute. • The delay start When you press the delay start button, the display shows the delay start time. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Refer to 'Troubleshooting' chapter. • Err The display shows this message for some seconds if: – You set a function that is not applicable for the programme. – You change the programme while it operates.
ENGLISH 5.9 Temperature button 9 Press button 9 to change the default temperature. 5.10 Child lock function This function prevents children to play with the control panel. • To activate the function, press button 6 and button 7 at the same time until the display shows the symbol . • To deactivate the function, press button 6 and button 7 at the same time until the symbol goes off. You can activate the function: • Before you press the Start/Pause button 4 : the appliance cannot start.
www.aeg.com Programme Temperature Type of load Cycle max. weight of load description Functions Synthetics 60° - Cold Synthetic or mixed fabric items with normal level of soil. max. 2,5 kg Wash Rinses Short spin SPIN REDUCTION RINSE HOLD LIQUID DETERGENT EXTRA RINSE TIME SAVE1) Synthetic fabric items Wash with normal soil. Rinses max.
ENGLISH Programme Temperature Type of load Cycle max. weight of load description Functions Set this programme to wash curtains. It adds automatically the prewash phase to clean the dust from the curtains. Do not put the detergent into the prewash compartment. max. 2,5 kg Prewash Wash Rinses Short spin SPIN REDUCTION RINSE HOLD LIQUID DETERGENT EXTRA RINSE All items in jeans. Jersey made items with hi-tech materials. max.
www.aeg.com pany for the washing of machine washable Woolmark product provided that the garments are washed according to the instructions on the garment label and those issued by the manufacturer of this washing machine. M1027 In UK, Eire, Hong Kong and India the Woolmark symbol is a certification trademark. 6.1 Woolmark Certificate The wool wash cycle of this machine has been approved by The Woolmark Com- 7. CONSUMPTION VALUES The data of this table are approximate.
ENGLISH Off Mode (W) Left On Mode (W) 0.48 0.48 13 The information given in the charts above are in compliance with the EU Commision regulation 1015/2010 implementing directive 2009/125/EC. 8. BEFORE FIRST USE Put a small quantity of detergent in the main wash compartment of the detergent dispenser. Set and start a programme for cotton at the highest tem- perature without laundry. This removes all possible dirt from the drum and the tub. 9. USING THE APPLIANCE 1. 2. Open the water tap.
www.aeg.com 9.2 Using detergent and additives • Measure out the detergent and the fabric conditioner. Detergent compartment for prewash phase. The marks MAX are the maximum levels for the quantity of detergent (powder or liquid). Detergent compartment for washing phase. The marks MAX are the maximum levels for the quantity of detergent (powder or liquid). Compartment for liquid additives (fabric conditioner, starch). The mark M is the maximum level for the quantity liquid additives.
ENGLISH 3. 15 4. CLICK B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. 9.3 Setting and starting a programme 1. 2. Turn the programme knob. The indicator of button 4 flashes with red colour. 3. The indicators of the default temperature and spin speed come on.
www.aeg.com Before you press button 4 to start the appliance, you can cancel or change the set of the delay start. 9.8 Cancel the delay start 1. Press button 4 . The related indicator flashes. 2. Press button 5 again and again until the display shows 0’. 3. Press button 4 . The programme starts. 9.9 Open the lid While a programme or the delay start operates, the lid is locked. To open the lid: 1. Press button 4 . You can open the lid 2 minutes after the appliance stops.
ENGLISH 17 10. HELPFUL HINTS AND TIPS 10.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items.
www.aeg.com • mmol/l (millimol for each litre - international unit for the hardness of water). • Clarke degrees. Water hardness table Level Type Water hardness °dH °T.H. mmol/l Clarke 1 soft 0-7 0-15 0-1.5 0-9 2 medium 8-14 16-25 1.6-2.5 10-16 3 hard 15-21 26-37 2.6-3.7 17-25 4 very hard > 21 > 37 >3.7 >25 11. CARE AND CLEANING WARNING! Disconnect the appliance from the mains supply before you clean it. 11.1 Descaling The water we use contains limescale.
ENGLISH 19 1. Remove the detergent dispenser and disconnect the two parts. 2. Clean all the parts with water. 3. Assemble the two parts of the detergent dispenser. 4. Put back the detergent dispenser. WARNING! • Disconnect the mains plug from the mains socket. • Do not remove the filter while the appliance operates. Do not clean the drain filter if the water in the appliance is hot. The water must be cold before you clean the drain filter. 11.
www.aeg.com To clean the water inlet filters: Close the water tap. Remove the water inlet hose from the water tap. 3. Clean the filter in the inlet hose with a stiff brush. 1. 2. 4. 5. 6. 7. Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap. 90˚ 11.7 Emergency drain 1. Because of a malfunction, the appliance cannot drain the water.
ENGLISH 21 WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 12. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water.
www.aeg.com Problem Possible cause Possible solution A washing programme without the drain phase is set. Set the drain programme. The function Rinse & Hold is on. Set the drain programme. The appliance door is open or not closed correctly. Close the door correctly. The anti-flood device is on. • Disconnect the appliance. • Close the water tap. • Contact the service centre. The spin phase does not operate. The programme does not start. There is water on the floor. The spin phase is off.
ENGLISH 23 Problem Possible cause The appliance makes an unusual noise. Incorrect level of the ap- Adjust the level of the applipliance. ance. Refer to 'Installation'. Possible solution You did not remove the packaging and/or the transit bolts. Remove the packaging and/or the transit bolts. Refer to 'Installation'. The load is very small. Add more laundry in the drum. The appliance fills The end of the drain with water and hose is too low. drain immediately.
www.aeg.com Spin speed Maximum 1000 rpm (L60060TL1) 1200 rpm (L60260TL1) 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 14. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste.
ENGLISH 25
www.aeg.
ENGLISH 27
108805100-A-462012 www.aeg.