User manual

To clean the water inlet filters:
1.
Close the water tap.
2.
Remove the water inlet hose from
the water tap.
3.
Clean the filter in the inlet hose with
a stiff brush.
4.
Remove the inlet hose behind the
appliance.
5.
Clean the filter in the valve with a
stiff brush or a towel.
90˚
6.
Install again the inlet hose. Make
sure that the couplings are tight to
prevent leakages.
7.
Open the water tap.
11.7 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (3) of
'To clean the drain filter'.
If necessary, clean the filter.
Put the drainage duct back and close the
drain filter flap.
11.8 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
1.
Close the water tap and disconnect
the inlet hose.
2.
Put the end of the inlet hose in a
container and let the water flow out
of the hose.
3.
Do the Drain programme and let it
operate until the end of the cycle.
4.
Turn the programme knob to Stop
to disconnect the appliance from the
power supply.
5.
Disconnect the appliance.
20
www.aeg.com