L 60260 MFL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 6 7 1 Worktop 2 Detergent dispenser 4. CONTROL PANEL 1 Cottons Eco 30 Min.
ENGLISH 4.1 Display 7 4.2 Wash phase indicators When you set a programme A and B indicators come on. • A – Prewash and wash indicator • B – Rinse and spin indicator After you have started the programme the only indicator of the running phase stays on. The machine starts to work. The door is locked. • The time area: • : the programme duration • : the delay start • : the alarm codes • : the message of error • : Programme is completed.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Synthetics + Prewash Synthetics with prewash 60° C - Cold Synthetic items or mixed fabric items. Normal soil. 3 kg, 1200 rpm Easy Iron Easy iron 60° C - Cold Synthetic fabric items. Normal soil. It prevents the laundry creases. 1 kg, 1200 rpm Delicate rinses Delicates 40 °C - Cold Delicate fabrics as acrylics, viscose, polyester items. Normal soil.
ENGLISH Programme Extra Rinse Spin Time Save Delay Start Mix 20° ■ ■ Jeans ■ ■ Synthetics ■ ■ ■ ■ ■ Synthetics + Prewash ■ ■ ■ ■ ■ Easy Iron ■ ■ ■ Delicate rinses ■ ■ ■ ■ ■ ■ ■ Wool/Silk Delicate Rinses ■ 9 ■ ■ ■ ■ ■ ■ ■ ■ Drain ■ Spin ■ ■ 30 Min. - 3 kg ■ Cottons Eco ■ ■ ■ ■ 6. CONSUMPTION VALUES The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature.
www.aeg.com Programmes Load (Kg) Standard 40 °C cotton Energy con- Water consumption sumption (li(kWh) tre) 3 0.52 32 Approximate programme duration (minutes) Remaining moisture (%)1) 141 53 Off Mode (W) Left On Mode (W) 0.10 0.98 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 1) At the end of spin phase. 7. OPTIONS 7.1 Temperature (Temp.°C) 7.
ENGLISH • To activate/deactivate this option, press Extra Rinse and Time Save at the same time until the indicator comes on/goes off. You can activate this option: • After you press Start/Pause, the options and the programme knob are locked. • Before you press Start/Pause: the appliance cannot start. 11 time until the indicator Extra Rinse comes on/goes off. 7.8 Acoustic signals The acoustic signals operate when: • The programme is completed. • The appliance has a malfunction.
www.aeg.com 9.2 Using detergent and additives • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. A 3. 4.
ENGLISH 13 • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.3 Setting a programme 1. Turn the programme knob and set the programme: • The indicator Start/Pause flashes. • The display shows the programme duration. 2.
www.aeg.com Open the appliance door when the delay start operates: 1. Press the Start/Pause to pause the appliance. 2. Wait until the door lock indicator goes off. 3. You can open the door. 4. Close the door and press the Start/ Pause again. The delay start continues to operate. Open the appliance door when the programme operates: 1. Turn the programme knob to On/ Off position to deactivate the appliance. 2. Wait for some minutes and then open the appliance door. 3. Close the appliance door. 4.
ENGLISH – Underwired bras. – Use a washing bag to wash small items. • A very small load can cause balance problems with the spin phase. If this occurs, adjust manually the items in the tub and start the spin phase again. 15 • If your appliance has not the detergent dispenser with the flap device, add the liquid detergents with a dosing ball. 10.4 Ecological hints For some stains, water and detergent is not sufficient. We recommend that you remove these stains before you put the items in the appliance.
www.aeg.com 11.3 Maintenance wash With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash. To do this: • Remove the laundry from the drum. • Set the cotton programme with the highest temperature with a small quantity of detergent. 11.4 Door seal Regularly examine the seal and remove all objects from the inner part. 11.5 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 11.
ENGLISH 1. 2. 1 1 2 3. 4. 2 1 5. 6. 1 7. 2 8.
www.aeg.com 9. 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 45° 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH 1. 2. 3. 4. 5. Disconnect the mains plug from the mains socket. Close the water tap. Remove the water inlet hose. Put the two ends of the inlet hose in a container and let the water flow out of the hose. Empty the drain pump. Refer to the emergency drain procedure. 6. 19 When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again.
www.aeg.com Problem Possible solution Make sure that the connection of the water inlet hose is correct. The appliance does not drain the water. Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct. Set the drain programme if you set a programme without drain phase.
ENGLISH Problem 21 Possible solution Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Service. 13.
www.aeg.com Spin drying performance (on scale from A to G, where A better and G - worse) Residual humidity B % 53 rpm 1200 Wash load kg 6 Average annual energy1) kW 3535 Average annual water consumption1) litres 173 Washing noise on normal 60° C cotton programme dB/A 56 Spinning noise on normal 60° C cotton programme dB/A 77 Maximum spin speed 1) Complies with EN60456. 14. ENVIRONMENT CONCERNS Recycle the materials with the symbol .
ENGLISH 23
132913622-A-162014 www.aeg.