L 60260 MFL L 60460 MFL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 6 7 1 Worktop 2 Detergent dispenser 4. CONTROL PANEL 1 Baumwolle Eco Aus 30 Min.
ENGLISH 4.1 Display 7 4.2 Wash phase indicators When you set a programme A and B indicators come on. • A – Prewash and wash indicator • B – Rinse and spin indicator After you have started the programme the only indicator of the running phase stays on. The machine starts to work. The door is locked. • The time area: • : the programme duration • : the delay start • : the alarm codes • : the message of error • : Programme is completed.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Pflegeleicht + Vorwäsche 60° C - Cold Synthetic items or mixed fabric items. Normal soil. 3 kg, 1200 rpm Leichtbügeln 60° C - Cold Synthetic fabric items. Normal soil. It prevents the laundry creases. 1 kg, 1200 rpm Feinwäsche 40 °C - Cold Delicate fabrics as acrylics, viscose, polyester items. Normal soil.
ENGLISH Extra Spülen Zeit Sparen Zeitvorwahl ■ ■ ■ ■ ■ ■ Programme U./Min. Koch/Bunt + Vorwäsche ■ Mix 20° ■ Jeans ■ ■ Pflegeleicht ■ ■ ■ ■ ■ Pflegeleicht + Vorwäsche ■ ■ ■ ■ ■ Leichtbügeln ■ ■ ■ Feinwäsche ■ ■ ■ ■ ■ ■ ■ Wolle/Seide Feinspülen 9 ■ ■ ■ ■ ■ ■ ■ ■ Pumpen Schleudern ■ 30 Min. - 3 kg ■ Baumwolle Eco ■ ■ ■ ■ ■ ■ 6. CONSUMPTION VALUES The data of this table are approximate.
www.aeg.com Programmes Load (Kg) Energy con- Water consumption sumption (li(kWh) tre) Approximate programme duration (minutes) Remaining moisture (%)1) Standard 60 °C cotton 3 0.58 32 150 532) / 523) Standard 40 °C cotton 3 0.52 32 141 532) / 523) Off Mode (W) Left On Mode (W) 0.10 0.98 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 1) At the end of spin phase. 2) For model L 60260 MFL .
ENGLISH 7.5 Delay Start (Zeitvorwahl) With this option you can delay the start of a programme from 30 minutes to 20 hours. The indicator of the option is on. 7.6 Child Lock With this option you can prevent that the children play with the control panel. • To activate/deactivate this option, press Extra Spülen and Zeit Sparen at the same time until the indicator comes on/goes off. You can activate this option: • After you press Start/Pause, the options and the programme knob are locked.
www.aeg.com 9. DAILY USE 9.1 Loading the laundry Open the appliance door. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. 3. Close the door. 1. 2. CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 9.2 Using detergent and additives • Measure out the detergent and the fabric conditioner.
ENGLISH 13 Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.3 Setting a programme 1. Turn the programme knob and set the programme: • The indicator Start/Pause flashes. • The display shows the programme duration. 2.
www.aeg.com 9.5 Starting a programme with the delay start • Press Zeitvorwahl again and again until the display shows the delay you want to set. • Press Start/Pause: The appliance starts the countdown. goes on. The indicator When the countdown is completed, the programme starts automatically. You can change or cancel the delay start before you press Start/ Pause. After pressing Start/Pause you can only cancel the delay. To cancel the delay start: 1. Press Start/Pause to set the appliance to PAUSE. 2.
ENGLISH To drain the water: 1. Set the Pumpen or the Schleudern programme. 2. Press Start/Pause. The appliance drains the water and spins. 3. When the programme is completed and the door lock indicator goes off, you can open the door 4. Turn the programme knob to Ein/ Aus position to deactivate the appliance. 15 Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced.
www.aeg.com • If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of the detergent, check the water hardness of your domestic system 10.5 Water hardness use a water softener for washing machines. In areas where the water hardness is soft it is not necessary to use a water softener. To know the water hardness in your area, contact your local water authority. Use the correct quantity of the water softener.
ENGLISH 11.5 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 1. 2.
www.aeg.com 3. 4. 2 1 5. 6. 1 7. 2 8. 1 2 9.
ENGLISH 19 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain 1. Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water.
www.aeg.com 12. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. Problem • - The appliance door is open or not closed correctly. Please check the door! • - The mains supply is unstable.
ENGLISH Problem 21 Possible solution Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again.
www.aeg.com 13.
ENGLISH 23
132913162-A-162014 www.aeg.
