L 60260 TL1 EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 ACCESSORIES . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. • If the appliance has a child safety device, we recommend you activate it. • Cleaning and user maintenance shall not be made by children without supervision. 1.
www.aeg.com • Adjust the feet to have the necessary space between the appliance and the carpet. Electrical connection WARNING! Risk of fire and electrical shock. • The appliance must be earthed. • Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician. • Always use a correctly installed shockproof socket. • Do not use multi-plug adapters and extension cables. • Make sure not to cause damage to the mains plug and to the mains cable.
ENGLISH 3. PRODUCT DESCRIPTION 1 7 2 8 9 3 10 11 4 5 6 12 1 Control panel 7 Rating plate 2 Lid 8 Mains cable 3 Lid handle 4 Filter access door 9 Water inlet valve 10 Water drain hose 5 Lever to move the appliance 11 Transit bolts 6 Adjustable feet 12 Feet for the appliance level 4. ACCESSORIES 1 2 3 1 Plastic cap To close the hole on the rear side of the cabinet, after the removal of the transit bolt. 2 Plastic hose guide To connect the drain hose on the edge of a sink.
www.aeg.com 5. CONTROL PANEL 1 2 3 9 1 On/Off button 8 7 6 5 4 • You do not use the appliance for 5 minutes before you press button 4 . – All settings are cancelled. – Press button 1 to activate the appliance again. – Set again the washing programme and all possible options. • After 5 minutes from the end of the washing programme. Refer to 'At the end of programme'.
ENGLISH 7 The display shows: A • The programme time When the programme starts, the time decreases with steps of 1 minute. • The delay start When you press the delay start button, the display shows the delay start time. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Refer to 'Troubleshooting' chapter. • Err The display shows this message for some seconds if: – You set a function that is not applicable for the programme. – You change the programme while it operates.
www.aeg.com 5.9 Temperature button 9 Press button 9 to change the default temperature. 5.10 Child lock function This function prevents children to play with the control panel. • To activate the function, press button 6 and button 7 at the same time until the display shows the symbol . • To deactivate the function, press button 6 and button 7 at the same time until the symbol goes off. You can activate the function: • Before you press the Start/Pause button 4 : the appliance cannot start.
ENGLISH Programme Temperature Type of load max. weight of load Synthetics (Synthetica - Synthétiques) 60° - Cold Synthetic or mixed Wash fabric items with nor- Rinses mal level of soil. Short spin max. 2,5 kg SPIN REDUCTION RINSE HOLD LIQUID DETERGENT EXTRA RINSE TIME SAVE1) Easy Iron (Strijkvrij - Repassage Facile)2) 60° - Cold Synthetic fabric items with normal soil. max.
www.aeg.com Programme Temperature Type of load max. weight of load Cycle description Functions Curtains (Gordijnen - Rideaux) 40° - Cold Set this programme to wash curtains. It adds automatically the prewash phase to clean the dust from the curtains. Do not put the detergent into the prewash compartment. max. 2,5 kg Prewash Wash Rinses Short spin SPIN REDUCTION RINSE HOLD LIQUID DETERGENT EXTRA RINSE Jeans 60° - Cold All items in jeans. Jersey made items with hi-tech materials. max.
ENGLISH 6.1 Woolmark Certificate The wool wash cycle of this machine has been approved by The Woolmark Com- 11 pany for the washing of machine washable Woolmark product provided that the garments are washed according to the instructions on the garment label and those issued by the manufacturer of this washing machine. M1027 In UK, Eire, Hong Kong and India the Woolmark symbol is a certification trademark. ©The Woolmark Company Pty Ltd. 7. CONSUMPTION VALUES The data of this table are approximate.
www.aeg.com 8. BEFORE FIRST USE Put a small quantity of detergent in the main wash compartment of the detergent dispenser. Set and start a programme for cotton at the highest tem- perature without laundry. This removes all possible dirt from the drum and the tub. 9. USING THE APPLIANCE 1. 2. Open the water tap. Connect the mains plug to the mains socket. 3. Press button 1 to activate the appliance. 4. Put the laundry in the appliance. 5. Use the correct quantity of detergent and additives. 6.
ENGLISH 13 Detergent compartment for washing phase. The marks MAX are the maximum levels for the quantity of detergent (powder or liquid). Compartment for liquid additives (fabric conditioner, starch). The mark M is the maximum level for the quantity liquid additives. Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. CLICK A 3. 4. CLICK B • Position A for powder detergent (factory setting). • Position B for liquid detergent.
www.aeg.com 5. Press button 4 to start the programme. The indicator of button 4 is on with red colour. The drain pump can operate for a short time when the appliance fills water. 9.8 Cancel the delay start 1. Press button 4 . The related indicator flashes. 2. Press button 5 again and again until the display shows 0’. 3. Press button 4 . The programme starts. 9.4 Interrupt a programme 1. Press button 4 . The indicator flashes. 2. Press button 4 again. The washing programme continues. 9.
ENGLISH When you activate the appliance again, the display shows the end of the last set programme. Turn the programme knob to set a new cycle. • Remove the laundry from the appliance. Make sure that the drum is empty. • Keep the door ajar, to prevent mildew and odours. • Close the water tap. The washing programme is completed, but the 'Rinse Hold' function is on: – The drum turns regularly to prevent the creases in the laundry. – The door stays locked. 15 – You must drain the water to open the door.
www.aeg.com 10.4 Ecological hints To help the environment, use less water and energy, obey these instructions: • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry. • If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of the detergent, check the water hardness of your domestic system use a water softener for washing machines.
ENGLISH • Use a correct quantity of powder detergent with biological properties. 17 After each wash, keep the door open for a while to prevent mould and to let unpleasant smells go out. 11.4 Detergent dispenser To clean the dispenser: 1. Remove the detergent dispenser and disconnect the two parts. 2. Clean all the parts with water. 3. Assemble the two parts of the detergent dispenser. 4. Put back the detergent dispenser. WARNING! • Disconnect the mains plug from the mains socket.
www.aeg.com 2. 3. 4. 5. 6. 7. 8. Put a container below the recess of the drain filter to collect the water that flows out. Turn the filter until it is vertical. Turn the filter fully and remove it. Remove fluff and objects. Clean the filter with water. Put it back and screw it in. Make sure that you tighten correctly the filter to prevent leakages. Close the drain filter door. 11.6 The inlet hose filter and the valve filter WARNING! • Disconnect the mains plug from the mains socket.
ENGLISH 6. 19 Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap. 7. 90˚ 11.7 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (3) of 'To clean the drain filter'. If necessary, clean the filter. Put the drainage duct back and close the drain filter flap. 2. Put the end of the inlet hose in a container and let the water flow out of the hose. 3.
www.aeg.com Problem Possible cause Possible solution The water inlet hose is damaged. Make sure that the water inlet hose has no damages. The filters in the water inlet hose is blocked . Clean the filters. Refer to 'Care and cleaning'. The water tap is blocked Clean the water tap. or is furred with limescale. The connection of the water inlet hose is not correct. Make sure that the connection is correct. The water pressure is too low. Contact your local water authority.
ENGLISH Problem There is water on the floor. 21 Possible cause Possible solution Blow out fuse in the household fuse box. Replace the fuse. You did not press button 4 . Press button 4 . The delay start is set. To start immediately the programme, cancel the delay start. The Child Lock function is activated. Deactivate the Child Lock function. Leakages from the couplings of the water hoses. Make sure that the couplings are tight. Leakages from the drain Make sure that the drain pump pump.
www.aeg.com 13.
ENGLISH 23
108783700-A-382012 www.aeg.