User manual

ManualsBrandsAEG ManualsWashersL61271WDBI

Problem Possible solution

The washing results are

not satisfactory.

• Increase the detergent quantity or use a different deter-

gent.

• Use special products to remove the stubborn stains before

you wash the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

You cannot set an op-

tion.

• Make sure that you press only the wanted button(s).

The machine does not

dry or does not dry prop-

erly:

• Make sure that you have set a suitable drying programme

for your laundry.

• Make sure that you set the correct the drying time or dry-

ness degree.

• Make sure that the water tap is not turned on.

• the drain filter is not clogged.

• Make sure you have not overloaded the appliance.

The laundry is full of dif-

ferent coloured fluff:

The fabrics washed in the previous cycle released fluff of a dif-

ferent colour.

• Clean the clothes with a fluff remover

• The drying phase helps to eliminate some fluff.

In case of an excessive amount of fluff in the drum, refer to sec-

tion «FLUFF IN THE FABRICS».

• Thoroughly clean the empty drum, the gasket and the door

with a wet rag.

• Perform a rinse cycle.

• Put a wool or piled fabric rag inside the drum.

• Perform a drying cycle of 10 minutes.

• Remove the old wool cloth.

Now you can wash other garments.

After the check, activate the appliance.

The programme continues from the

point of interruption.

If the problem occurs again, contact the

Authorised Service Centre.

If the display shows other alarm codes.

Deactivate and activate the appliance. If

the problem continues, contact the

Service.

16. INSTALLATION

16.1 Unpacking

WARNING!

Remove all the packaging and the transit bolts before installing the

appliance.