User manual

ManualsBrandsAEG ManualsWashersL61271WDBI

Problem Possible cause/Solution

The machine vibrates

or is noisy:

The transit bolts and packing have not been re-

moved.

• Check the correct installation of the appliance.

The support feet have not been adjusted

• Check the correct levelling of the appliance.

The laundry is not evenly distributed in the drum.

• Redistribute the laundry.

Maybe there is very little laundry in the drum.

• Load more laundry.

Spinning starts late or

the machine does not

spin:

The electronic unbalance detection device has cut in

because the laundry is not evenly distributed in the

drum. The laundry is redistributed by reverse rota-

tion of the drum. This may happen several times be-

fore the unbalance disappears and normal spinning

can resume. If, after some minutes, the laundry is still

not evenly distributed in the drum, the machine will

not spin.

• The laundry load is perhaps to little, add more

items, redistribute the load manually and then se-

lect the spinning programme.

The machine does not

dry or does not dry

properly:

The drying time has not been selected.

• Select the drying time.

The water tap is not turned on.

• Open the water tap.

The drain filter is clogged.

• Clean the drain filter.

The machine is overloaded.

• Reduce the laundry load.

The selected drying time or dryness degree was not

suitable for the laundry.

• Select the suitable drying time or the dryness de-

gree for the laundry.

The machine makes an

unusual noise:

The machine is fitted with a type of motor which

makes an unusual noise compared with other tradi-

tional motors. This new motor ensures a softer start

and more even distribution of the laundry in the

drum when spinning, as well as increased stability of

the machine.

No water is visible in

the drum:

Machines based on modern technology operate

very economically using very little water without af-

fecting performance.

The display shows the

alarm code

Anti-flooding system has activated.

• Pull out the plug from the power socket, close the

water tap and contact the Service Force Centre.