User manual

10. DAILY USE
10.1 Loading the laundry
Open the water tap. Connect the mains
plug to the mains socket.
1. Pull the door handle to open the
appliance door.
2. Put the laundry in the drum, one item
at a time.
3. Shake the items before you put them
in the appliance.
Make sure not to put too much laundry
in the drum. Refer to "Programmes"
chapter for the maximum recommended
loads.
4. Close the door.
CAUTION!
Make sure that no laundry
becomes trapped between
the seal and the door. There
is a risk of water leakage or
damage to the laundry.
10.2 Filling the detergent and
other treatments
MAX
Compartment for prewash phase,
soak programme or stain remover.
Compartment for washing phase.
Compartment for liquid treatments
(fabric conditioner, starch).
Maximum level for quantity of liquid
treatments.
Always follow the
instructions that you find on
the packaging of the
detergent products.
10.3 Setting a programme
Turn the programme selector dial to the
required programme.
The programme dial determines the type
of washing cycle (e.g. water level, drum
movement, number of rinses) and the
washing temperature according to the
type of laundry.
The indicator of Start/Pause button starts
flashing.
The programme dial can be turned
either clockwise or anticlockwise.
Off = Reset programme/switching OFF
of the appliance
If you turn the programme
dial to another programme
when the appliance is
working, the yellow indicator
of Start/Pause button flashes
3 times. The display shows
the message Err to indicate
a wrong selection. The
appliance does not perform
the newly selected
programme.
10.4 Starting the programme
without the delay start
Press the Start/Pause button to start the
programme. The corresponding red
indicator stops flashing.
The indicator Washing is on to indicate
that the appliance starts operating.
The indicator Door is on to indicate the
door is locked.
www.aeg.com
14