User manual

3.
Clean the valve filter on the back of the
appliance with a toothbrush.
4.
45°
20°
When you reconnect the hose to the back of
the appliance, do not turn the inlet hose
downwards, but turn it left or right depending
on the position of your water tap.
12.8 Emergency emptying out
If the appliance does not drain the water,
proceed as follows:
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. If necessary, wait until the water has
cooled down.
4. Place a bowl on the floor and put the
end of the emergency emptying
hose into the bowl. Remove its cap.
The water should drain into the bowl.
5. When the bowl is full, put the cap
back on the emergency hose.
6. Empty the bowl. Repeat the
procedure until water stops flowing.
7. Clean the pump if necessary as
previously described ("Cleaning the
drain filter").
8. Ensure the cap is back on the
emergency emptying hose and insert
back into position.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.
12.9 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Place the end of the emergency
emptying hose and that of the inlet
hose in a bowl placed on the floor
and let water flow out of the hoses.
4. Select the draining programme and
let it operate until the end of the
cycle.
5. Turn the programme dial to Off to
disconnect the appliance from the
power supply.
6. Screw the water inlet hose back on
and re-fit the emergency emptying
hose after having put the cap on
again.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
ENGLISH 21