User manual

Problem Possible solution
There is water on the
floor.
• Make sure that the couplings of the water hoses are tight
and there is not water leakages.
• Make sure that the drain hose have no damages.
• Make sure you use the correct detergent and the correct
quantity of it.
• Make sure you have replaced the emergency emptying cap
into the filter
• Make sure you have properly screwed the filter in after
cleaning.
You cannot open the ap-
pliance door.
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the
drum.
The appliance makes an
unusual noise.
• Make sure the levelling of the appliance is correct. Refer to
'Installation'.
• Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
• Add more laundry in the drum. The load may be too small.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different deter-
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
You cannot set an op-
tion.
• Make sure that you press only the wanted button(s).
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Authorised Service Centre.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the
Service.
14. INSTALLATION
14.1 Unpacking
WARNING!
Remove all the packaging and the transit bolts before installing the
appliance.
ENGLISH 23