User manual

Connect the water inlet hose to the
cold water tap with 3/4 thread.
CAUTION!
Make sure that there are no leaks
from the couplings.
Do not use an extension hose if
the inlet hose is too short. Con-
tact the service centre for the re-
placement of the inlet hose.
Water pressure
The appliance works correctly if the wa-
ter pressure is not less than 0.05 MPa
(0.5 bar).
If you can not connect the water inlet
hose to the cold water tap of the primary
hydraulic system, connect it to your do-
mestic cold water storage system.
Make sure not to have more than a dis-
tance of 5.02 m (16.5 ft) between the ap-
pliance inlet hose and the bottom of the
water storage tank.
Water-stop device
13.4 Water drainage
There are different procedures to con-
nect the drain hose:
With the plastic hose guide.
30
www.aeg.com