User manual

Problem Possible cause/Solution
The machine does not
dry or does not dry
properly:
The drying time has not been selected.
• Select the drying time.
The water tap is not turned on.
• Open the water tap.
The drain filter is clogged.
• Clean the drain filter.
The machine is overloaded.
• Reduce the laundry load.
The selected drying time or dryness degree was not
suitable for the laundry.
• Select the suitable drying time or the dryness de-
gree for the laundry.
The machine makes an
unusual noise:
The machine is fitted with a type of motor which
makes an unusual noise compared with other tradi-
tional motors. This new motor ensures a softer start
and more even distribution of the laundry in the
drum when spinning, as well as increased stability of
the machine.
No water is visible in
the drum:
Machines based on modern technology operate
very economically using very little water without af-
fecting performance.
The display shows the
alarm code
:
Anti-flooding system has activated.
• Pull out the plug from the power socket, close the
water tap and contact the Service Force Centre.
The laundry is full of
different colored fluff:
The fabrics washed in the previous cycle released
fluff of a different colour.
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the
drum repeat the following procedure twice:
• Thoroughly clean the empty drum, the gasket and
the door with a wet rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
(1*/,6+ 29