User manual

time the drum continues to turn at
regular intervals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
On/Off.
• Set the DRAIN or SPIN programme.
• Reduce the spin speed, if needed.
• Press button Start/Pause.
• When the programme has finished
the display shows a blinking . The
indicator Door goes off. The door can
be opened.
Turn the programme selector dial to
On/Off to switch the appliance off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
10.11 Stand by
Once the programme has finished, after
few minutes the energy saving system
will be enable. The brightness of the
display is reduced. By pressing any
button the appliance comes out from the
energy saving status.
11. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
11.1 Drying setting
The recommended load size
is 3 kg for cottons and linen,
and 2 kg for synthetic items.
You can also to dry up to 4
kg of cotton items (see the
«Drying Programme » table).
WARNING!
Open the water tap. Put
the drain hose in the sink
or connect to the drain
pipe.
1.
Load the laundry one item at a time.
2. Turn the programme dial to the
programme applicable for the items
to dry (cottons or synthetics).
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
11.2 Timed drying
1. Press the button Drying time again
and again to set the time value (see
the «Programmes for timed drying»
table).
• Each time you press this button
the time value increases by 5
minutes.
• As the appliance calculates also
the duration of the anti-crease
and the cooling phases, the
programme time will
automatically increase by some
minutes.
2. Press Start/Pause button to start the
programme.
• The display shows regularly a new
time value.
• The indicator is on.
If you set only 10 minutes of
drying, the appliance
performs only a cooling
phase.
If the laundry is not sufficient dry, set
again a short drying time.
11.3 End of the drying
programme
The appliance stops automatically.
• The acoustic signals operate (if they
are active).
• In the display comes on.
• The indicator of the Start/Pause
button goes off.
ENGLISH
17