User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. PROGRAMMES
- 6. CONSUMPTION VALUES
- 7. OPTIONS
- 8. SETTINGS
- 9. BEFORE FIRST USE
- 10. DAILY USE
- 10.1 Loading the laundry
- 10.2 Filling the detergent and additives
- 10.3 Setting a programme
- 10.4 Starting the programme
- 10.5 Starting a programme with the delay start
- 10.6 Altering an option or a running programme
- 10.7 Interrupting a programme
- 10.8 Cancelling a running programme
- 10.9 Opening the door
- 10.10 At the end of the programme
- 10.11 Stand by
- 11. DAILY USE - DRYING ONLY
- 12. DAILY USE - WASHING & DRYING
- 13. HINTS AND TIPS
- 14. CARE AND CLEANING
- 15. TROUBLESHOOTING
- 16. INSTALLATION
- 17. TECHNICAL DATA
On the edge of a sink
• Make sure that the plastic guide cannot
move when the appliance drains. Attach
the guide to the water tap or the wall.
To a stand pipe with vent-hole
• Directly into a drain pipe at a height of not
less than 60 cm (23.6”) and not more than
100 cm (39.3”). Refer to the illustration.
• The end of the drain hose must always be
ventilated , i.e. the inner diameter of the
drain pipe (min. 38 mm - min. 1.5”) must
be larger than the external diameter of the
drain hose.
Drain hose end
• If the end of the drain hose looks like this
(see the picture), you can push it directly
into the stand pipe.
Without the plastic hose guide.
To a sink spigot
• Refer to the illustration. Put the drain hose
in the spigot and tighten it with a clip.
• Make sure that the drain hose makes a
loop to prevent that remaining particles
go in the appliance from the sink.
www.aeg.com32