EN User Manual Washing Machine L 62270 FL
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. CONTROL PANEL...........................................................................................................7 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
ENGLISH • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • This appliance complies with the E.E.C. Directives. 2.3 Water connection • Do not cause damage to the water hoses. • Before connection to new pipes, pipes not used for a long time, where repair work has been carried out or new devices fitted (water meters, etc.), let the water flow until it is clean and clear. • Ensure that there are no visible water leaks during and after the first use of the appliance. 2.
www.aeg.com 3. PRODUCT DESCRIPTION 3.1 Appliance overview 1 2 3 4 5 1 2 3 4 5 6 7 Worktop Detergent dispenser Control panel Door handle Rating plate Drain pump filter Feet for levelling the appliance 6 7 3.2 Available from your authorized dealer Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. Fixing plate kit (4055171146) Available from your authorised dealer.
ENGLISH 4. CONTROL PANEL 4.1 Control panel description 1 2 3 9 8 7 6 6 Time saving button 1 On/Off button 2 Programme knob 3 Display 7 Extra rinse button 8 Spin button 4 Start/Pause button 9 Temperature button 5 Delay start button 4.2 Display A B Time area: A 5 Programme duration Delay start Alarm codes Message of error Programme is completed.
www.aeg.com Door lock indicator: B You cannot open the appliance door when the indicator is on. You cannot open the appliance door when the indicator flashes. Wait for some minutes before you open the door. You can open the door only when the indicator goes off. Child safety lock: C The indicator comes on when you activate this device. 5. PROGRAMMES 5.
ENGLISH Programme Temperature range Maximum load Programme description Maximum spin (Type of load and soil level) speed Spin 7 kg 1200 rpm To spin the laundry and to drain the water in the drum. All fabrics, except woollens and delicate fabrics. 7 kg To drain the water in the drum. All fabrics. 7 kg 1200 rpm To rinse and spin the laundry. All fabrics, except woollens and very delicate fabrics. Reduce the spin speed accordingly to the type of laundry.
www.aeg.com Programme options compatibility Programme 1) 2) ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 3) ■ 1) If you set Extra Rinse option, the appliance adds some additional rinses. In the Rinse programme, if you set a low spin speed the appliance performs delicate rinses and a short spin. 2) If you set a shorter duration, we recommend that you decrease the load size.
ENGLISH 11 At the start of the programme, the display shows the programme duration for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can be greatly reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 7 kg, the programme duration exceeds 2 hours; actual load 1 kg, the programme duration will be less than 1 hour).
www.aeg.com 7. OPTIONS 7.1 Temperature Set this option to change the default temperature. Indicator = cold water. The indicator of the set temperature comes on. 7.2 Spin With this option you can decrease the default spin speed. The indicator of the set speed comes on. Additional spin options: Rinse Hold • Set this option to prevent the laundry creases. • The relevant indicator comes on. • The washing programme stops with the water in the drum. The drum turns regularly to prevent the laundry creases.
ENGLISH until the indicator comes on/goes off. You can activate this option: • After you press Start/Pause : the options and the programme knob are locked. • Before you press Start/Pause : the appliance cannot start. 13 8.3 Permanent Extra Rinse With this option you can permanently have an extra rinse when you set a new programme. • To activate/deactivate this option press and at the same time until the relevant indicator comes on/ goes off. 9. BEFORE FIRST USE 1.
www.aeg.com 10.3 Check the position of the flap 1. Pull out the detergent dispenser until it stops. 2. Press the lever down to remove the dispenser. 1 2 3. To use powder detergent, turn the flap up. A With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on in the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6.
ENGLISH The programme starts, the door is locked. The display show the indicator . The drain pump can operate for a short time when the appliance fills water. 10.7 Behaviour of the appliance After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the cycle time to the laundry you have put in the drum to have perfect washing results in the minimum necessary time. • The display shows the new time value. 10.8 Starting a programme with the delay start 1.
www.aeg.com 10.13 Opening the door when the delay start is active The drum turns regularly to prevent the creases in the laundry. While the delay start operates, the appliance door is locked. To open the appliance door: The door lock indicator door stays locked. is on. The 1. Press button Start/Pause. You must drain the water to open the door: In the display the door lock indicator goes off. 2. Open the appliance door. 3. Close the door and press button Start/Pause. The delay start continues.
ENGLISH 11.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash white and coloured items together. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items.
www.aeg.com 12. CARE AND CLEANING 12.3 Maintenance wash WARNING! Refer to Safety chapters. With the low temperature programmes it is possible that some detergent stays in the drum. Perform a maintenance wash regularly. To do this: 12.1 External cleaning Clean the appliance with soap and warm water only. Fully dry all the surfaces. • Remove all laundry from the drum. • Select the cotton programme with the highest temperature with a small quantity of detergent.
ENGLISH 3. 4. 12.6 Cleaning the drain filter Do not clean the drain filter if the water in the appliance is hot. 1. 2. 1 1 2 3. 4.
www.aeg.com 5. 6. 1 7. 2 8. 1 2 9.
ENGLISH 21 12.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 45° 20° 13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water properly.
www.aeg.com 13.2 Possible failures Problem Possible solution The programme does not start. Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box. Make sure that the Start/Pause has been pressed. If the delay start is set, cancel the setting or wait for the end of countdown. Deactivate the Child Lock function if it is on. The appliance does not fill with water properly.
ENGLISH Problem 23 Possible solution Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor. Make sure that the couplings of the water hoses are tight and there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quantity of it.
www.aeg.com 14.
ENGLISH 25
www.aeg.
ENGLISH 27
132947200-A-442015 www.aeg.