L 6227 FL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 6 7 1 Worktop 2 Detergent dispenser 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 4. CONTROL PANEL Algodón Eco 20 Min.
ENGLISH • 4.1 Display A B C A) The time area: • • : the programme duration : the delay start • : the alarm codes 7 : the message of error • : Programme is completed. B) The door lock indicator: • You cannot open the appliance door when the indicator is on. • You cannot open the appliance door when the indicator flashes. Wait for some minutes before you open the door. • You can open the door only when the indicator goes off.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Aclarado Cold To rinse and spin the laundry. All fabrics. 7 kg, 1200 rpm Mixtos1) 20 °C Special programme for cotton, synthetic and mixed fabrics with light soil. Set this programme to decrease the energy consumption. 3.5 kg, 1200 rpm Tejidos Gruesos 60 °C – Cold Items in denim and jersey. Also for items in dark colours. 8 kg, 1200 rpm 20 Min.
ENGLISH Programme Centrif. Tejidos Gruesos ■ 20 Min. - 3 kg ■ ■ Algodón Eco ■ 9 Aclarado Extra Ahorra Tiempo Inicio Diferido ■ ■ ■ ■ ■ ■ ■ ■ 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can greatly be reduced if the laundry load is lower than the maximum load capacity (e.g.
www.aeg.com Programmes Load (Kg) Energy con- Water consumption sumption (li(kWh) tre) Approximate programme duration (minutes) Remaining moisture (%)1) The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 1) At the end of spin phase. 7. OPTIONS 7.1 Temperature (Temp. ) 7.4 Time save (Ahorra Tiempo) Set this option to change the default temperature. Indicator = cold water.
ENGLISH 7.7 Permanent extra rinse With this option you can permanently have an extra rinse when you set a new programme. • To activate/deactivate this option press Ahorra Tiempo and Inicio Diferido at the same time until the indicator Aclarado Extra comes on/goes off. 11 • You activate the appliance. • You deactivate the appliance. • You press the buttons. • The programme is completed. • The appliance has a malfunction. To deactivate/activate the acoustic signals, press Temp. and Centrif.
www.aeg.com 9.2 Using detergent and additives • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. A 3. 4.
ENGLISH 13 • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.3 Activating the appliance Press Marcha/Parada to activate or deactivate the appliance. A tune sounds when the appliance is activated. 9.4 Setting a programme 1.
www.aeg.com 9.9 Opening the door While a programme or the delay start operates, the appliance door is locked and the display shows the indicator . CAUTION! If the temperature and level of the water in the drum are too high, you cannot open the door. Open the appliance door when the delay start operates: 1. Press Inicio/Pausa to pause the appliance. 2. Wait until the door lock indicator goes off. 3. Open the door. 4. Close the door and press Inicio/Pausa again. The delay start continues to operate.
ENGLISH 15 10. HELPFUL HINTS AND TIPS 10.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items. • Some coloured items can discolour with the first wash. We recommend that you wash them separately for the first times. • Button up pillowcases, close zippers, hooks and poppers. Tie up belts. • Empty the pockets and unfold the items.
www.aeg.com 11. CARE AND CLEANING WARNING! Before maintenance, disconnect the appliance from the mains supply. Regularly examine the drum to prevent limescale and rust particles. To remove rust particles use only special products for washing machine. Do this separately from the laundry wash. Always obey the instructions that you find on the packaging of the product. 11.1 External cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces.
ENGLISH 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 1. 2. 1 1 2 3. 4.
www.aeg.com 5. 6. 1 7. 2 8. 1 2 9.
ENGLISH 19 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain 1. Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water.
www.aeg.com 12. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water. • - The appliance does not drain the water. Problem • - The appliance door is open or not closed correctly. Please check the door! • - The mains supply is unstable.
ENGLISH Problem 21 Possible solution Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again.
www.aeg.com After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Service. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Service. 13.
ENGLISH 23
132913680-A-182013 www.aeg.
