L 62080 FL L 62280 FL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 6 7 1 Worktop 2 Detergent dispenser 4. CONTROL PANEL 1 2 Algodón Eco 20 Min.
ENGLISH • 4.1 Display A B C A) The time area: • • : the programme duration : the delay start • : the alarm codes 7 : the message of error • : Programme is completed. B) The door lock indicator: • You cannot open the appliance door when the indicator is on. • You cannot open the appliance door when the indicator flashes. Wait for some minutes before you open the door. • You can open the door only when the indicator goes off.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Mixtos 20°1) 20 °C Special programme for cotton, synthetic and mixed fabrics with light soil. Set this programme to decrease the energy consumption. 3 kg, 1000 rpm (L62080FL), 1200 rpm (L62280FL) Tejido Gruesos 60 °C – Cold Items in denim and jersey. Also for items in dark colours. 8 kg, 1000 rpm (L62080FL), 1200 rpm (L62280FL) 20 Min. - 3 kg Cotton and synthetic items with light soil or worn only one time.
ENGLISH 9 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can greatly be reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 8 kg, the programme duration exceeds 2 hours; real load 1 kg, the programme duration don’t reach 1 hour).
www.aeg.com 7. OPTIONS 7.1 Temperature (Temp.) Set this option to change the default temperature. = cold water. Indicator The indicator of the set temperature comes on. 7.2 Spin (Centrif.) With this option you can change the default spin speed. The indicator of the set speed comes on. Additional spin options: Rinse Hold • Set this option to prevent the laundry creases. • The related indicator comes on. • There is a water in the drum when the programme is completed.
ENGLISH 11 8. BEFORE FIRST USE Put 2 litre of water in the detergent compartment for washing phase. This activates the drain system. 2. Put a small quantity of detergent in the compartment for washing phase. 1. 3. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. 9. DAILY USE 9.1 Loading the laundry 1. 2. Open the appliance door. Put the laundry in the drum, one item at a time.
www.aeg.com Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.3 Activating the appliance Press Marcha/Parada to activate or deactivate the appliance. A tune sounds when the appliance is activated. 9.
ENGLISH • The drain pump can operate for a short time when the appliance fills water. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 9.6 Starting a programme with delay start • Press Inicio Diferido again and again until the display shows the delay you want to set. • Press Inicio/Pausa: – The appliance starts the countdown.
www.aeg.com The washing programme is completed, but there is water in the drum: – The drum turns regularly to prevent the creases in the laundry. – The door lock indicator is on. The door stays locked. – You must drain the water to open the door. To drain the water: If necessary, decrease the spin speed. 2. Press Inicio/Pausa. The appliance drains the water and spins. 3. When the programme is completed and the door lock indicator goes off, you can open the door. 4.
ENGLISH 10.3 Detergents and additives • Only use detergents and additives specially made for washing machines. • Do not mix different types of detergents. • To help the environment, do not use more than the correct quantity of detergent. • Obey the instructions that you find on the on packaging of these products. • Use the correct products for the type and colour of the fabric, the programme temperature and the level of soil.
www.aeg.com 11.4 Door seal Regularly examine the seal and remove all objects from the inner part. 11.5 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot.
ENGLISH 1. 2. 1 1 2 3. 4. 2 1 5. 6. 1 7. 2 8.
www.aeg.com 9. 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 45° 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH 1. 2. 3. 4. 5. Disconnect the mains plug from the mains socket. Close the water tap. Remove the water inlet hose. Put the two ends of the inlet hose in a container and let the water flow out of the hose. Empty the drain pump. Refer to the emergency drain procedure. 6. 19 When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again.
www.aeg.com Problem Possible solution Make sure that the connection of the water inlet hose is correct. The appliance does not drain the water. Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct. Set the drain programme if you set a programme without drain phase.
ENGLISH Problem 21 Possible solution Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Service. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Service. 13.
www.aeg.
ENGLISH 23
132916441-A-152013 www.aeg.