L 62283 FL FR Notice d'utilisation
www.aeg.com SOMMAIRE 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. CONSIGNES DE SÉCURITÉ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSTRUCTIONS DE SÉCURITÉ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 DESCRIPTION DE L'APPAREIL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 BANDEAU DE COMMANDE . . . . . . . . . . . . . . . . . . . . . . .
FRANÇAIS 3 1. CONSIGNES DE SÉCURITÉ Avant d'installer et d'utiliser cet appareil, lisez soigneusement les instructions fournies. Le fabricant ne peut être tenu pour responsable des dommages et blessures liés à une mauvaise installation ou utilisation. Conservez toujours cette notice avec votre appareil pour vous y référer ultérieurement. 1.1 Sécurité des enfants et des personnes vulnérables AVERTISSEMENT Risque d'asphyxie, de blessure ou d'invalidité permanente.
www.aeg.com • Ne modifiez pas les caractéristiques de cet appareil. • Respectez la charge maximale de 8 kg (reportez-vous au chapitre « Tableau des programmes »). • Si le câble d'alimentation est endommagé, il doit être remplacé par le fabricant, son atelier d'entretien ou un technicien qualifié afin d'éviter tout danger.
FRANÇAIS • • • • remplacement du cordon d'alimentation de l'appareil doit être effectué par notre service après-vente. Ne connectez la fiche d'alimentation à la prise de courant qu'à la fin de l'installation. Assurez-vous que la prise de courant est accessible une fois l'appareil installé. Ne tirez jamais sur le câble d'alimentation électrique pour débrancher l'appareil. Tirez toujours sur la prise. Ne touchez jamais le câble d'alimentation ou la prise avec des mains mouillées.
www.aeg.com 3. DESCRIPTION DE L'APPAREIL 1 2 4 Poignée d'ouverture du hublot 3 5 Plaque signalétique 6 Filtre de la pompe de vidange 7 Pieds pour la mise à niveau de l'ap- pareil 4 3.1 Kit de plaques de fixation (4055171146) 5 Servez-vous de cet accessoire spécial lorsque vous installez l'appareil sur un socle. Il empêche les mouvements de l'appareil lorsque ce dernier est en cours de fonctionnement. Lisez attentivement la notice fournie avec cet accessoire.
FRANÇAIS • 4.1 Affichage A B C A) La zone de l'horloge : • • : la durée du programme : le départ différé • : les codes d'alarme • : le message d'erreur 7 : Le programme est terminé. B) Le voyant Hublot verrouillé : • Vous ne pouvez pas ouvrir le hublot de l'appareil lorsque cet indicateur est allumé. • Vous ne pouvez pas ouvrir le hublot de l'appareil lorsque ce voyant clignote.
www.aeg.com Programme Plage de températures Type de charge et degré de salissure Charge maximale, vitesse d'essorage maximale Vidange Pour vidanger l'eau du tambour. Tous textiles. 8 kg Rinçage Froid Pour rincer et essorer le linge. Tous textiles. 8 kg, 1200 tr/min Mix 20°1) 20 °C Programme spécial pour le coton, les textiles synthétiques et mixtes légèrement sales. Sélectionnez ce programme pour diminuer la consommation d'énergie.
FRANÇAIS Programme Délicats Laine/Soie Essorage ■ ■ ■ ■ Rinçage Plus Gain de Temps Départ Différé ■ ■ ■ ■ ■ Essorage 9 ■ Vidange Rinçage ■ ■ ■ ■ Mix 20° ■ ■ ■ ■ Jeans ■ ■ ■ ■ 20 Min. - 3 kg ■ ■ ■ ■ ■ Coton Eco ■ ■ ■ 6. VALEURS DE CONSOMMATION Au démarrage du programme, l'affichage indique la durée du programme pour la charge maximale. Durant la phase de lavage, la durée du programme est calculée automatiquement.
www.aeg.com Programmes Charge (kg) Consommation énergétique (kWh) Consomma- Durée ap- Taux d'hution d'eau proximative midité res(litres) du protant (%)1) gramme (minutes) Coton 60 °C standard 8 1.02 56 242 53 Coton 60 °C standard 4 0.78 44 211 53 Coton 40 °C standard 4 0.59 44 191 53 Mode « Éteint » (W) Mode « Veille » (W) 0.48 0.
FRANÇAIS Certains programmes n'acceptent qu'une seule de ces deux fonctions. 7.5 Départ différé (Départ Différé) Cette option vous permet de différer le départ du programme de 30 minutes à 20 heures. Le voyant de l'option est allumé. 7.6 Sécurité enfants Avec cette option, vous pouvez empêcher les enfants de jouer avec le bandeau de commande. • Pour activer/désactiver cette option, appuyez simultanément sur les touches Rinçage Plus et Gain de Temps s'allume/ jusqu'à ce que le voyant s'éteigne.
www.aeg.com 9. UTILISATION QUOTIDIENNE 9.1 Chargement du linge Ouvrez le hublot de l'appareil. Mettez le linge dans le tambour, un article à la fois. Dépliez-les le plus possible. Assurez-vous de ne pas surcharger le tambour. 3. Fermez le hublot. 1. 2. ATTENTION Veillez à ce qu'il n'y ait pas de linge coincé entre le joint et le hublot. Cela pourrait provoquer une fuite d'eau ou endommager le linge. 9.2 Utilisation de lessive et d'additifs • Dosez le produit de lavage et l'assouplissant.
FRANÇAIS 13 Lessive liquide ou en poudre 1. 2. A 3. 4. B • Position A pour la lessive en poudre (réglage d'usine). • Position B pour la lessive liquide. Si vous utilisez une lessive liquide : – N'utilisez pas de lessives liquides gélatineuses ou épaisses. – Ne dépassez pas le niveau maximal. – Ne sélectionnez pas de phase de prélavage. – Ne sélectionnez pas la fonction Départ différé. 9.3 Activation de l'appareil Appuyez sur Marche/Arrêt pour allumer ou éteindre l'appareil.
www.aeg.com • La pompe de vidange peut momentanément se mettre en route lorsque l'appareil se remplit d'eau. Au bout d'environ 15 minutes après le départ du programme : • L'appareil règle automatiquement la durée du programme en fonction de la charge de linge. • La nouvelle valeur s'affiche. 9.6 Démarrage d'un programme avec départ différé • Appuyez sur Départ Différé à plusieurs reprises jusqu'à ce que le délai que vous souhaitez sélectionner s'affiche.
FRANÇAIS • Le voyant Départ/Pause s'éteint. • Le voyant de verrouillage du hublot s'éteint. • Sortez le linge de l'appareil. Vérifiez que le tambour est vide. • Laissez le hublot entrouvert pour éviter la formation de moisissures et l'apparition de mauvaises odeurs. • Fermez le robinet d'eau. • Appuyez sur Marche/Arrêt pendant quelques secondes pour éteindre l'appareil.
www.aeg.com – Utilisez un sac de lavage pour les articles très petits. • Une très petite charge peut provoquer des problèmes d'équilibre pendant la phase d'essorage. Si cela se produit, répartissez manuellement les articles dans la cuve et lancez à nouveau la phase d'essorage. 10.2 Taches tenaces Pour certaines taches, l'eau et les produits de lavage ne suffisent pas. Il est recommandé d'éliminer ces taches avant de mettre les articles dans l'appareil. Des détachants spéciaux sont disponibles.
FRANÇAIS Pour éliminer les particules de rouille, utilisez uniquement des produits spéciaux pour lave-linge. N'effectuez pas cette opération avec du linge dans la machine. Respectez toujours les instructions figurant sur l'emballage du produit. 17 de lavage restent dans le tambour. Procédez à un entretien régulier. Pour ce faire : • Retirez le linge du tambour. • Sélectionnez le programme pour le coton à température maximale avec une petite quantité de détergent. 11.
www.aeg.com 11.6 Nettoyage du filtre de vidange AVERTISSEMENT Ne nettoyez pas le filtre de vidange si l'eau dans l'appareil est chaude. 2. 1. 1 1 2 3. 4. 2 1 5. 6.
FRANÇAIS 7. 19 8. 1 2 9. 11.7 Nettoyage du tuyau d'arrivée d'eau et du filtre de la vanne 1. 2.
www.aeg.com 3. 4. 20° 11.8 Vidange d'urgence 1. L'appareil ne vidange pas à cause d'une anomalie de fonctionnement. Si cela se produit, répétez les étapes (1) à (9) du chapitre « Nettoyage du filtre de vidange ». Si nécessaire, nettoyez la pompe. Lorsque vous appliquez la procédure de vidange d'urgence, vous devez réactiver le système de vidange : 1. Versez 2 litres d'eau dans le compartiment de lavage principal du distributeur de produit de lavage. 2. Démarrez le programme pour vidanger l'eau. 2.
FRANÇAIS Problème 21 Solution possible Le programme ne dé- Assurez-vous que la fiche du câble d'alimentation est marre pas. bien insérée dans la prise de courant. Vérifiez que le couvercle de l'appareil est fermé. Assurez-vous qu'aucun fusible n'a disjoncté dans la boîte à fusibles. Assurez-vous que la touche Départ/pause est enfoncée. Si vous avez sélectionné un départ différé, annulez-le ou attendez la fin du décompte. Désactivez la fonction Sécurité enfants si elle a été préalablement activée.
www.aeg.com Problème Solution possible Assurez-vous que le filtre de vidange n'est pas obstrué. Nettoyez le filtre, si nécessaire. Reportez-vous au chapitre « Entretien et nettoyage ». Répartissez manuellement les vêtements dans la cuve et lancez à nouveau la phase d'essorage. Ce problème peut être dû à des problèmes d'équilibrage. Il y a de l'eau sur le sol. Assurez-vous que les raccords des tuyaux d'eau sont bien serrés et qu'il n'y a aucune fuite d'eau.
FRANÇAIS 23 13.
123909290-A-362013 www.aeg.