L 62670 FL EN User manual
www.aeg.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.aeg.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 1 2 3 Control panel 3 4 Door handle 5 Rating plate 6 Drain pump filter 7 Feet for the appliance level 4 5 6 7 1 Worktop 2 Detergent dispenser 3.1 Fixing plate kit (4055171146) Use this special accessory, when you install the appliance on a plinth. It prevents the movements of the appliance when it operates. Read carefully the instructions supplied with this accessory. You can buy it in all approved Service. 4.
ENGLISH • 4.1 Display A B C A) The time area: • • • : the programme duration : the delay start : the alarm codes 7 : the message of error • : Programme is completed. B) The door lock indicator: • You cannot open the appliance door when the indicator is on. • You cannot open the appliance door when the indicator flashes. Wait for some minutes before you open the door. • You can open the door only when the indicator goes off.
www.aeg.com Programme Temperature range Type of load and soil Maximum load, Maximum spin Spülen Cold To rinse and spin the laundry. All fabrics. 7 kg, 1600 rpm Mix 20°1) 20 °C Special programme for cotton, synthetic and mixed fabrics with light soil. Set this programme to decrease the energy consumption. 3.5 kg, 1200 rpm Jeans 60 °C – Cold Items in denim and jersey. Also for items in dark colours. 7 kg, 1200 rpm 20 Min. - 3 kg Cotton and synthetic items with light soil or worn only one time.
ENGLISH Programme U./Min. ■ Baumwolle Eco ■ Extra Spülen Zeit Sparen Zeitvorwahl ■ ■ ■ 9 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can greatly be reduced if the laundry load is lower than the maximum load capacity (e.g.
www.aeg.com 1) At the end of spin phase. 7. OPTIONS 7.1 Temperature (Temp.) Set this option to change the default temperature. Indicator = cold water. The indicator of the set temperature comes on. 7.2 Spin (U./Min.) With this option you can change the default spin speed. The indicator of the set speed comes on. Additional spin options: Rinse Hold • Set this option to prevent the laundry creases. • The related indicator comes on. • There is a water in the drum when the programme is completed.
ENGLISH To deactivate/activate the acoustic signals, press Temp. and U./Min. at the same time for 6 seconds. 11 If you deactivate the acoustic signals, they continue operate when the appliance has a malfunction. 8. BEFORE FIRST USE Put 2 litre of water in the detergent compartment for washing phase. This activates the drain system. 2. Put a small quantity of detergent in the compartment for washing phase. 1. 3. Set and start a programme for cotton at the highest temperature without laundry.
www.aeg.com Compartment for liquid additives (fabric conditioner, starch). Flap for powder or liquid detergent. Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.
ENGLISH 9.5 Starting a programme without delay start 3. Press Start/Pause: • The indicator Start/Pause stops to flash and stays on. • The programme starts, the door is locked and the display shows the indi. cator • The drain pump can operate for a short time when the appliance fills water. 9.8 Cancel a programme After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 9.
www.aeg.com • Remove the laundry from the appliance. Make sure that the drum is empty. • Keep the door ajar, to prevent the mildew and odours. • Close the water tap. • Press Ein/Aus for some seconds to deactivate the appliance. The washing programme is completed, but there is water in the drum: – The drum turns regularly to prevent the creases in the laundry. – The door lock indicator is on. The door stays locked. – You must drain the water to open the door.
ENGLISH We recommend that you remove these stains before you put the items in the appliance. Special stain removers are available. Use the special stain remover that is applicable to the type of stain and fabric. 10.3 Detergents and additives • Only use detergents and additives specially made for washing machines. • Do not mix different types of detergents. • To help the environment, do not use more than the correct quantity of detergent.
www.aeg.com • Set the cotton programme with the highest temperature with a small quantity of detergent. 11.4 Door seal Regularly examine the seal and remove all objects from the inner part. 11.5 Cleaning the detergent dispenser 1. 2. 1 2 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot.
ENGLISH 1. 2. 1 1 2 3. 4. 2 1 5. 6. 1 7. 2 8.
www.aeg.com 9. 11.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 20° 11.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 45° 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH 1. 2. 3. 4. 5. Disconnect the mains plug from the mains socket. Close the water tap. Remove the water inlet hose. Put the two ends of the inlet hose in a container and let the water flow out of the hose. Empty the drain pump. Refer to the emergency drain procedure. 6. 19 When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again.
www.aeg.com Problem Possible solution Make sure that the filter of the inlet hose and the filter of the valve are not clogged. Refer to “Care and cleaning”. Make sure that the inlet hose has no kinks or bends. Make sure that the connection of the water inlet hose is correct. The appliance does not drain the water. Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary.
ENGLISH 21 Problem Possible solution The appliance fills with water and drain immediately. Make sure that the drain hose is in the correct position. The hose may be too low. The washing results are not satisfactory. Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. After the check, activate the appliance.
www.aeg.com appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
ENGLISH 23
132913281-A-122015 www.aeg.
