User manual

10.7 Starting a programme
without the Finish In option
Touch the button Start/Pause .
• The indicator of the button Start/
Pause stops to flash and stays on.
• The programme starts, the door
locks, the indicator is on.
• The drain pump can operate for a
short time at the beginning of the
washing cycle.
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the
programme duration
agree with the laundry
load.
• The display shows the
new value.
10.8 Starting a programme
with the Finish In option
1. Touch the button again and again
to choose the number of hours in
which you want the washing cycle to
be finished.
The display shows the number of hours
you set (e.g.
) and the indicator above
the button
is on to show that his
option is active.
2. Touch the button Start/Pause :
• The door is locked.
• The appliance starts the
countdown.
• When the countdown is
completed, the programme starts
automatically.
You can cancel or change
the set of the
option
before you touch the button
Start/Pause . After touching
the button Start/Pause you
can only cancel the Finish In
option.
To cancel the
option:
a. Touch the button Start/Pause to
set the appliance to pause. The
indicator of button Start/Pause
flashes.
b. Touch the button
until the
indicator above this button goes
off.
Touch the button Start/Pause
again to start the programme
immediately.
10.9 Interrupting a
programme and changing the
options
You can change only some options
before they operate.
1. Touch Start/Pause .
The indicator of this button flashes.
2. Change the options. If you change
any option the Finish In option (if set)
will be disabled.
3. Touch Start/Pause again.
The programme continues.
10.10 Cancelling a running
programme
1. Press the button On/Off for some
seconds to cancel the programme
and to deactivate the appliance.
2. Press the same button again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.11 Opening the door
While a programme (or the Finish In)
operates, the appliance door is locked.
The indicator
is on.
CAUTION!
If the temperature and level
of the water in the drum are
too high, you cannot open
the door.
To open the door during the first
minutes of the cycle (or when the
Finish In operates) :
ENGLISH
15