EN User Manual Washing Machine LAVAMAT 69470FL LAVAMAT 69670FL LAVAMAT 69470VFL LAVAMAT 69670VFL
www.aeg.com CONTENTS 1. SAFETY INFORMATION.................................................................................................3 2. SAFETY INSTRUCTIONS................................................................................................ 4 3. PRODUCT DESCRIPTION.............................................................................................. 6 4. CONTROL PANEL...........................................................................................................6 5.
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.
www.aeg.com • • • • • • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
ENGLISH 5 • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • UK and Ireland only. This appliance is fitted with a 13 A mains plug. If it is necessary to change the mains plug fuse, use only a 13 A ASTA (BS 1362) fuse. • This appliance complies with the E.E.C. Directives. • Make sure that all metal objects are removed from the laundry. • Do not put a container to collect possible water leakage under the appliance.
www.aeg.com 3. PRODUCT DESCRIPTION 3.1 Appliance overview 1 2 3 1 2 3 4 5 6 7 4 Worktop Detergent dispenser Control panel Door handle Rating plate Drain pump filter Feet for levelling the appliance 5 6 7 3.2 Installation on suspended flooring mm thick, under the appliance. It should be screwed to at least 2 floor beams and should extend beyond the front feet. Suspended wooden floors are particularly susceptible to vibration.
ENGLISH 2 Programme selection touchpad (Programmes) 3 Temperature selection touchpad (Temp.) 4 Spin selection touchpad (Spin) 5 Options selection touchpad (Option) 6 7 8 9 7 Start/Pause touchpad (Start/Pause) Finish In touchpad (Finish In) Display Door locked indicator ( ) 4.2 Display A. The time area: • • Finish In A B D C : the programme duration : the "finish in" time • : the alarm codes • : the message of error • : the programme is completed. B.
www.aeg.com Programme Temperature range Programme description (Type of load and soil level) Maximum load Maximum spin speed Machine washable wool, hand washable wool and delicate Wool/Handwash 40°C - Cold fabrics with «hand washing» care symbol.2) 1,5 kg, 1200 rpm 30 Min - 3 Kg 30°C A short cycle for synthetic and delicate items with light soil level or for items to freshen up. 3 kg; 800 rpm Mix 20° 20°C Special programme for cotton, synthetic and mixed fabrics with light soil.
30 Min - 3 Kg Mix 20° ■ ■ ■ Easy Iron ■ ■ ■ ■ ■ ■ ■ ■ Finish In ■ Drain & Spin Wool/Handwash Rinse Only Programme Super Quick 1) Quick1) Spin Prewash ENGLISH ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 9 ■ 1) When you set this option, we recommend that you decrease the quantity of the laundry. It is possible to keep the full load but the washing results can be unsatisfactory. Recommended load: cotton: 3,5 kg, synthetics and delicates: 1,5 kg. 5.
www.aeg.com At the start of the programme, the display shows the programme duration for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can be greatly reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 7 kg, the programme duration exceeds 2 hours; actual load 1 kg, the programme duration will be less than 1 hour).
ENGLISH Off Mode (W) 11 Left On Mode (W) The information given in the chart above is compliant with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 7. OPTIONS 7.1 Spin The related indicator comes on. With this option you can change the default spin speed. 7.4 Super Quick The indicator of the set speed comes on. Additional spin options: • Set this option to deactivate all spin phases. Only the drain phase is available. • The related indicator comes on.
www.aeg.com 7.8 Extra Rinse The related indicator comes on.1) With this option you can add some rinses to a washing programme. Use this option for persons allergic to detergents and in areas where the water is soft. 8. SETTINGS 8.1 Permanent Extra Rinse With this option you can permanently have an extra rinse when you set a new programme. • To activate/deactivate this option touch the buttons Spin and Option at the same time until the indicator comes on/goes off. 8.
ENGLISH 13 3. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. 4. Close the door firmly. 10.3 Detergent compartments CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 10.2 Using detergent and additives 1. Measure out the detergent and the fabric conditioner. 2. Put the detergent and the fabric conditioner into the compartments. 3.
www.aeg.com 10.4 Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid then the maximum level. • Do not set the prewash option. • Do not set the delay start (or Finish in option). 10.5 Activating the appliance Press and hold for a couple of seconds the On/Off button to activate or deactivate the appliance.
ENGLISH 10.7 Starting a programme without the Finish In option Touch the button Start/Pause . • The indicator of the button Start/ Pause stops to flash and stays on. • The programme starts, the door locks, the indicator is on. • The drain pump can operate for a short time at the beginning of the washing cycle. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 10.
www.aeg.com 2. Wait until the indicator goes off. 3. You can open the door. 4. Close the door and touch the button Start/Pause again. The programme (or the Finish In) continues. 10.12 AUTO-OFF option The AUTO-OFF stand-by option automatically deactivates the appliance to decrease the energy consumption. All the indicators and the display go off when : • You do not use the appliance for 5 minutes before you touch the Start/ Pause. Press the button On/Off to activate the appliance again.
ENGLISH 17 11.4 Ecological hints 11.5 Water hardness • Set a programme without the prewash phase to wash laundry with normal soil. • Always start a washing programme with the maximum load of laundry allowed. • If necessary, use a stain remover when you set a programme with a low temperature. • To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness".
www.aeg.com 12.5 Cleaning the detergent dispenser 1. 2. 3. 4. 12.6 Cleaning the drain filter Do not clean the drain filter if the water in the appliance is hot. 1. 2.
ENGLISH 3. 4. 1 5. 2 6. 2 1 7. 8. 2 9.
www.aeg.com 12.7 Cleaning the inlet hose and the valve filter 1. 2. 1 2 3 3. 4. 45° 20° 12.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
ENGLISH 21 13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. With some problems, the acoustic signals operate and the display shows an alarm code: • - The appliance does not fill with water properly. • - The appliance does not drain the water.
www.aeg.com Problem Possible solution The appliance does not fill with water properly. Make sure that the water tap is open. Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged. Make sure that the filter of the inlet hose and the filter of the valve are not clogged. Refer to “Care and cleaning”. Make sure that the inlet hose has no kinks or bends.
ENGLISH Problem Possible solution You cannot open the appliance door. Make sure that the washing programme is finished. 23 Set the drain or the spin programme if there is water in the drum. The appliance makes an unusual noise. Make sure the levelling of the appliance is correct. Refer to 'Installation'. Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation'. Add more laundry in the drum. The load may be too small. The cycle is shorter than the time displayed.
www.aeg.com Water supply pressure Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Cold water Water supply 1) Maximum Load Cotton 7 kg Energy Efficiency Class Spin Speed A+++ -20% Maximum 1400 rpm (L 69470FL/L 69470VFL) 1600 rpm (L 69670FL/L 69670VFL) 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 15. ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it.
ENGLISH 25
www.aeg.
ENGLISH 27
192964032-A-512015 www.aeg.